Rugged Handheld Computer - EA630 Plus - User's Manual Version 1.
Revision History Date Change Description Version 2022/6/29 first published version 1.0 2022/7/04 Add warning and label figure on p.13 1.
Preface About This Manual Thank you for purchasing the unitech product. This manual explains how to install, operate and maintain our product. No part of this publication may be reproduced or used in any form, or by any electrical or mechanical means, such as photocopying, recording, or information storage and retrieval systems, without permission in writing from the manufacturer. The material in this manual is subject to change without notice.
1. 2. 3. –Consult the dealer or an experienced radio/TV technician for help. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. To maintain compliance with FCC RF exposure requirements, avoid direct contact to the transmitting antenna during transmitting.
CE RF Exposure Compliance For body-worn operation, this device has been tested and meets the ICNIRP guidelines and the European Standard EN 62209-2, for use with dedicated accessories, SAR is measured with this device at a separation of 0.5 cm to the body, while transmitting at the highest certified output power level in all frequency bands of this device. Use of other accessories which contain metals may not ensure compliance with ICNIRP exposure guidelines.
for use on the head is 0.28 W/Kg and when worn on the body, as described in this user guide, is 0.75 W/Kg (Body-worn measurements differ among phone models, depending upon available accessories and FCC requirements). The maximum scaled SAR in hotspot mode is 0.59 W/Kg. While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirement for safe exposure.
IC SAR Information Statement Your Rugged Handheld Computer is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Innovation, Science and Economic Development Canada of the Canada Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population.
mode is 0.59 W/Kg. While there may be differences between the SAR levels of various Rugged Handheld Computer and at various positions, they all meet the government requirement for safe exposure. The ISED has granted an Equipment Authorization for this Rugged Handheld Computer with all reported SAR levels evaluated as in compliance with the ISED RF exposure guidelines. SAR information on this Rugged Handheld Computer is on file with the FCC and can be found under the Display Grant section of https://sms-sgs.
RoHS Statement This device conforms to RoHS (Restriction Of Hazardous Substances) European Union regulations that set maximum concentration limits on hazardous materials used in electrical and electronic equipment. Waste Electrical and Electronic Equipment (WEEE) unitech has set up a policy and process to meet the 2012/19/EU concerning electronic waste disposal.
Taiwan NCC Warning Statement NCC 警語 取得審驗證明之低功率射頻器材,非經核准,公司、商號或使用者均不得擅自變 更頻率、加大功率或變更原設計之特性及功能。低功率射頻器材之使用不得影響 飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無干擾 時方得繼續使用。前述合法通信,指依電信管理法規定作業之無線電通信。低功 率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 應避免影響附近雷達系統之操作。高增益指向性天線只得應用於固定式點對點系 統。 注意事項: 1. 使用過度恐傷害視力。 2. 使用30分鐘請休息10分鐘;未滿2歲幼兒不看螢幕,2歲以上每天看螢幕不要超過 1小時。 3. 減少電磁波影響,請妥適使用。 Note: Within the 5.25-5.35 GHz band, U-NII devices will be restricted to indoor operations to reduce any potential for harmful interference to co-channel MSS operations.
Laser Information The unitech product is certified in the U.S. to conform to the requirements of DHHS/CDRH 21CFR Subchapter J and to the requirements of IEC 60825-1. Class II and Class 2 products are not considered to be hazardous. The unitech product contains internally a Visible Laser Diode (VLD) whose emissions do not exceed the maximum limits as set forth in the above regulations.
Battery Notice 1. To guarantee optimal performance, it is recommended that rechargeable batteries be replaced every year, or after 500 charging cycles are completed. It is normal for the battery to balloon or expand after one year or 500 cycles. Although it does not cause damage, it cannot be used again and must be disposed of according to the location's safe battery disposal procedures. 2. If a battery performance decreases more than 20%, the battery is at the end of its life cycle.
4. 5. 6. 7. period of time, the battery will wear out and the longevity of the battery will be at least half of one with frequent charges. Protect battery life by not over or under charging the battery. Please do not leave battery unused for long time without charging it. Despite unitech’s safety precautions, the battery pack may begin to change shape. If so, stop using it immediately.
Battery Charge Notice It is important to consider temperature when the battery pack is charging. Charging is most efficient at normal room temperature or in a slightly cooler environment. It is essential that batteries are charged within the stated range of 0°C to 40°C. Charging batteries outside of the specified range could damage the batteries and shorten their life cycle. CAUTION! Do not charge batteries at a temperature lower than 0°C. This will make the batteries unstable and dangerous.
Storage and Safety Notice Although charged batteries may be left unused for several months, their capacity may be depleted due to build up of internal resistance. If this happens, they will require recharging prior to use. Batteries may be stored at temperatures between -20°C to 60°C, however they may deplete more rapidly at higher temperatures. It is recommended to store batteries at room temperature. * The message above only applies to the usage of the removable batteries.
Hearing Damage Warning To prevent possible hearing damage, do not listen at high volume levels for long periods. 5.2 GHz 帯域は屋内での使用のみに制限されています (5.2 GHz 高電力基地局または中継局と通信する場合を除く) 電波法により 5.3 GHz 帯は屋内使用に限ります Label EA630 Plus with Label xiii © 2022 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Worldwide Support unitech’s professional support team is available to quickly answer questions or assist with technical-related issues. Should an equipment problem occur, please contact the nearest unitech regional service representative. For complete contact information please visit the Web sites listed below: Taipei, Taiwan – Headquarters Europe Tel: +886-2-89121122 Tel: +31-13-4609292 E-mail: info@hq.ute.com E-mail: info@eu.ute.com Address: 5F, No.
Warranty Policy The following items covered under the unitech Limited Warranty are free from defects during normal use: The warranty period is varied from each country. Please consult with your supplier or unitech local office for actual length of warranty period to your purchased product. Warranty becomes void if equipment is modified, improperly installed or used, damaged by accident or neglect, or if any parts are improperly installed or replaced by the user. xv © 2022 unitech Electronics Co., Ltd.
Table of Contents Preface ............................................................................................................. i Regulatory Compliance Statements .............................................................. i Laser Information ........................................................................................ vi LED Information .......................................................................................... vi Battery Notice .........................................
EA630 Plus User’s Manual Chapter 1 - Overview 1.1 Package Please make sure the following contents are in the EA630 Plus gift box. If something is missing or damaged, please contact your unitech representative. The basic package contents EA630 Plus Terminal Battery Quick Start Guide Regulatory Compliance Statements Optional accessories Stylus Hand strap Quick charge adaptor (via USB type-C cable) USB 3.
EA630 Plus User’s Manual 1.2 Product Detail EA630 Plus Front View Receiver LED indicator Front camera 2 © 2022 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 Plus User’s Manual EA630 Plus Rear View Flash LED Speaker Rear camera Hand strap hole Pogo Pin connector for extension modules NFC Battery cover 3 © 2022 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 Plus User’s Manual EA630 Plus Left and Right View Power key Volume up/down Scanner trigger key Function key Scanner trigger key 4 © 2022 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 Plus User’s Manual Barcode scanner window Pogo pin Pogo pin (For Cradle Charging) (For Cradle Charging) USB Type C Port 5 © 2022 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 Plus User’s Manual 1.3 Specifications System Features CPU 2GHz, Qualcomm® Snapdragon™ 662 64bits Octa-core Processor Memory 4 GB RAM 64 GB Flash Expanded Slot MicroSD, up to 256GB OS Android 11 Languages Support Multiple languages Display Capacitive type 5 points multi-touch touch panel with Gorilla® Glass 5, 6”,18:9 Full-HD ( 2160 x 1080 ) color screen (450nits) Indicator 1 x LED indicator Speaker, Vibrator 6 © 2022 unitech Electronics Co., Ltd. All rights reserved.
EA630 Plus User’s Manual Functionality Symbologies 1D: UPC/EAN/JAN, GS1 DataBar, Code 39, Code 128, Code 32, Code 93, Codabar/NW7, Interleaved 2 of 5, Matrix 2 of 5, MSI, Trioptic 2D: PDF417, MicroPDF417, GS1 Composite, Code11, Aztec Code, Data Matrix, QR Code, Micro QR Code, MaxiCode, Han Xin Code, DOT Code Postal: Intelligent Mail Barcode, Postal-4i, Australian Post, Japanese Post, Netherlands (KIX) Post, Postnet, Planet Code OCR: OCR-A, OCR-B, E13B (MICR) Audio One speaker (95±3Db @ 10cm), One receiver
EA630 Plus User’s Manual Enclosure Weight 232g (with battery) Dimension 157mm x 76.4mm x 13.9mm (HxWxD) Environmental Operating Temperature -10°C to 50°C Storage - 30°C to 70°C (without battery) Temperature Charging temperature 0°C to 45°C Relative Humidity 10% ~ 90% (non-condensing) Durability Drop Specification 1.2m, 1.
EA630 Plus User’s Manual 1.4 Getting Started 1.4.1 Remove/Install Battery Cover 1. To Unlock the battery cover, turn the knobs a quarter of a turn (90°). 2. And pull the battery up to remove it. 9 © 2022 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 Plus User’s Manual 1. To lock the battery cover by turning the knobs a quarter of a turn (90°). Make sure the battery cover is securely closed, or you may be unable to turn on the terminal. WARNING! There is a risk of fire and burns if the battery is handled improperly. DO NOT disassemble, crush, puncture, short external contacts, or dispose the battery pack in fire or water. DO NOT attempt to open or service the battery.
EA630 Plus User’s Manual 1.4.2 Charging Battery Before using the terminal for the first time, you need to charge it for about 24 hours. For the regular use, you can charge the terminal with QC (quick charge) USB type-C cable and QC adapter for within 2.5 hours to full capacity. It takes within 4 hours to charge the terminal with the cradle to full capacity. Connect the type C USB cable to the USB port on EA630 Plus and the other end of the USB cable.
EA630 Plus User’s Manual 1.4.3 Turning on Terminal for the First Time It is recommended to fully charge EA630 Plus before first use. You can now start up your device to set up the languages, WLAN setting, date and time. Power Button Turn ON your device by pressing the power button on the side of the terminal. power button 12 © 2022 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 Plus User’s Manual 1.4.4 Checking LED status LED Description ■ Battery Charging ■ Twinkling to indicate battery low Red Light Terminal status(less than 15%) ■ Battery Fully charged Green Light ■ Barcode scan good read Blue Light Message All of LEDs can be controlled by software API If scanner app is running, LED control by scanner app.