Rugged Handheld Computer - EA630 - User's Manual Version 1.0 © 2020 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Revision History Date Change Description Version © 2020 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Preface About This Manual Thank you for purchasing the unitech product. This manual explains how to install, operate and maintain our product. No part of this publication may be reproduced or used in any form, or by any electrical or mechanical means, such as photocopying, recording, or information storage and retrieval systems, without permission in writing from the manufacturer. The material in this manual is subject to change without notice.
1. 2. 3. which the receiver is connected. –Consult the dealer or an experienced radio/TV technician for help. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. To maintain compliance with FCC RF exposure requirements, avoid direct contact to the transmitting antenna during transmitting.
CE RF Exposure Compliance For body-worn operation, this device has been tested and meets the ICNIRP guidelines and the European Standard EN 62209-2, for use with dedicated accessories, SAR is measured with this device at a separation of 0.5 cm to the body, while transmitting at the highest certified output power level in all frequency bands of this device. Use of other accessories which contain metals may not ensure compliance with ICNIRP exposure guidelines.
RoHS Statement This device conforms to RoHS (Restriction Of Hazardous Substances) European Union regulations that set maximum concentration limits on hazardous materials used in electrical and electronic equipment. Waste electrical and electronic equipment (WEEE) unitech has set up a policy and process to meet the 2012/19/EU concerning electronic waste disposal.
Taiwan NCC Warning Statement 低功率電波輻射性電機管理辦法 第十二條:經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者 均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 第十四條:低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有 干擾現象時,應立即停用,並改善至無干擾時方得繼續使用。 前項合法通信,指依電信法規定作業之無線電通信。 低功率射頻電機需忍受合法通信或工業、科學及醫療用電波輻射性電機設備 之干擾。 SAR標準值2.0W/KG, 送測產品實測值為: 0.395 (W/KG) 注意事項: 1. 使用過度恐傷害視力。 2. 使用30分鐘請休息10分鐘;未滿2歲以下幼兒不看螢幕,2歲以上每天看螢幕不要 超過1小時。 3. 減少電磁波影響,請妥適使用。 4. 因應各地區/國家開放頻道不同,請依據當地主管機關與電信業者實際公告資訊 為主,如服務細則有所變更,請自行洽詢電信業者,恕不另通知。 5. 無線資訊傳輸設備避免影響附近雷達系統之操作 Note: Within the 5.25-5.
Laser Information The unitech product is certified in the U.S. to conform to the requirements of DHHS/CDRH 21CFR Subchapter J and to the requirements of IEC 60825-1. Class II and Class 2 products are not considered to be hazardous. The unitech product contains internally a Visible Laser Diode (VLD) whose emissions do not exceed the maximum limits as set forth in the above regulations.
Battery Notice 1. To guarantee optimal performance, it is recommended that rechargeable batteries be replaced every year, or after 500 charging cycles are completed. It is normal for the battery to balloon or expand after one year or 500 cycles. Although it does not cause damage, it cannot be used again and must be disposed of according to the location's safe battery disposal procedures. 2. If a battery performance decreases more than 20%, the battery is at the end of its life cycle.
4. 5. 6. 7. Do not leave the battery uncharged and unused for an extended period of time, the battery will wear out and the longevity of the battery will be at least half of one with frequent charges. Protect battery life by not over or under charging the battery. Please do not leave battery unused for long time without charging it. Despite unitech’s safety precautions, the battery pack may begin to change shape. If so, stop using it immediately.
temperature detecting device for a charger to ensure a safe charging temperature range. CAUTION! To ensure the unit working properly, please keep all connectors away from the contaminants staying inside of them such as dust, grease, mud, and water. The negligence may cause the unit with no communication, short circuited, overheated and so on. CAUTION! If the connector is damaged, please ensure the connector is being fully repaired before use the unit to avoid causing short circuited.
Storage and safety notice Although charged batteries may be left unused for several months, their capacity may be depleted due to build up of internal resistance. If this happens, they will require recharging prior to use. Batteries may be stored at temperatures between -20°C to 60°C, however they may deplete more rapidly at higher temperatures. It is recommended to store batteries at room temperature. * The message above only applies to the usage of the removable batteries.
Hearing Damage Warning To prevent possible hearing damage, do not listen at high volume levels for long periods. xi © 2019 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Worldwide Support unitech’s professional support team is available to quickly answer questions or assist with technical-related issues. Should an equipment problem occur, please contact the nearest unitech regional service representative. For complete contact information please visit the Web sites listed below: Taipei, Taiwan – Headquarters Europe Tel: +886-2-89121122 Tel: +31-13-4609292 E-mail: info@hq.ute.com E-mail: info@eu.ute.com Address: 5F, No.
Warranty Policy The following items covered under the unitech Limited Warranty are free from defects during normal use: The warranty period is varied from each country. Please consult with your supplier or unitech local office for actual length of warranty period to your purchased product. Warranty becomes void if equipment is modified, improperly installed or used, damaged by accident or neglect, or if any parts are improperly installed or replaced by the user. xiii © 2019 unitech Electronics Co., Ltd.
Table of Contents Preface............................................................................................................. i Regulatory Compliance Statements .............................................................. i Laser Information ........................................................................................ vi LED Information .......................................................................................... vi Battery Notice...........................................
EA630 User’s Manual Chapter 1 - Overview 1.1 Package Please make sure the following contents are in the EA630 gift box. If something is missing or damaged, please contact your unitech representative. The basic package contents EA630 Rugged Handheld Computer Battery USB Type C Cable Quick Start Guide Regulatory Compliance Statements Optional accessories Terminal Power Adapter (with US or EU plug) Hand Strap Cradle + Cradle Adapter 1 © 2020 unitech Electronics Co., Ltd.
EA630 User’s Manual 1.2 Product Detail EA630 Front View Receiver LED indicator Function key Trigger key 2 © 2020 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 User’s Manual EA630 Rear View Flash LED Speaker Rear camera Hand strap hole Pogo Pin connector for extension modules NFC Battery cover 3 © 2020 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 User’s Manual EA630 Left and Right View Volume up/down Scanner trigger key Power key Function key Scanner trigger key 4 © 2020 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 User’s Manual Barcode scanner window Pogo pin Pogo pin (For Cradle Charging) (For Cradle Charging) USB Type C Port 5 © 2020 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 User’s Manual 1.
EA630 User’s Manual Audio One speaker (95±3dB @ 10cm), One receiver , Dual noise-cancelling microphones Regulatory Approvals CE, FCC, NCC, VCCI, CCC, RoHS, CEC, BQB, GMS, N-Mark compliance Communication USB USB 3.1 (type-C) support USB OTG Camera 16 MP Rear and Flash Light Bluetooth® Bluetooth® 5 supported WLAN Wireless LAN 802.11a/b/g/n/ac, 2.4GHz and 5GHz Support 802.11d/e/f/h/i/k/r/v, fast roaming Compliant with WEP, WPA and IEEE 802.
EA630 User’s Manual +/-8KV direct discharge, +/-15KV air discharge ESD Software Android 9 GMS (Android is a trademark of Google LLC. ) Note: The device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range. AT BE BG EE FI FR IT LV LT PT RO SK IS LI NO HR DE LU SI CH CY EL MT ES TR CZ DK HU IE NL PL SE UK 8 © 2020 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
EA630 User’s Manual 1.4 Getting Started 1.4.1 Remove / Install the Battery Cover 1. To unlock the battery cover by turning the knobs a quarter of a turn (90°). 2. And pull the battery up to remove it. 3. To lock the battery cover by turning the knobs a quarter of a turn (90°). Make sure the battery cover is securely closed, or you may be unable to turn on the terminal. WARNING! There is a risk of fire and burns if the battery is handled improperly.
EA630 User’s Manual 1.4.2 Charging the Battery Before using the terminal for the first time, you need to charge it for about 24 hours. For the regular use, you can charge the terminal for 4 hours to recharge the battery to full capacity. Charge the terminal using the USB charging cable or the cradle. Connect the type C USB cable to the USB port on EA630 and the other end of the USB cable please connect to AC power adapter into the electrical outlet on the USB plug.
EA630 User’s Manual 1.4.3 Turning on the terminal for the first time It is recommended to fully charge EA630 before first use. You can now start up your device to set up the languages, WLAN setting, and date and time. Power-On Button Turn ON your device by pressing the power button on the side of the terminal. 1.4.