The Sensor of bike trainers User Manual For model No. JSLC02 / JDLY01 Jinhua Unisky Tools Co., Ltd.
►Caution *Do not ingest battery. Chemical burn hazard. *[The remote control supplied with] This product contains a coin/button cell battery. If the coin / button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. *Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children.
*The new trainer pod comes with a battery insulation sheet that must be removed from the battery compartment before use. Cadence mode 1.Remove and reinstall the battery and the red indicator lights up to indicate that the pod is in cadence mode. 2.Install the flat silicone gasket on the bottom of the pod and install the pod on the inside of the left crank using a rubber ring. Rotate the crank and search for the pod using an Bluetooth device Power trainer mode 1.
.We will complete the power calibration by adjusting the resistance. step 1.Turn the adjusting screw to ensure that the tire and the roller just touch, this is "0 resistance" step2. After reaching "0 resistance", We suggest you make the tires fully stressed by turning the adjusting knob for 0-3 laps. The greater the number of turns, the greater the resistance. step3.
2.When using the Bluetooth protocol, you can only connect to one device or APP concurrently. Please disconnect the previous device or APP when you want to change it. 3.When using a smartphone app, you need to search for the pod in the app, searching through the phone system's bluetooth settings is invalid. 4.After the pod is removed, it will automatically enter the sleep state for 1 minute to save power. Accessories: Pod.
►FAQ 1.Why is the pod not discovered by other equipment when it's not used for a long time? A: In order to save battery enenrgy .the pod will go to sleep when it detects no data for 1 minute. Normal broadcasting will resume when the device is used 2.Why doesn't the indicator light illuminate when reinstaling the battery? A: It's possible the battery connector is covered with foreign contaminate or the spring is not pushed up.
►Onelap Utility app Install the onelap Utility app on a Bluetooth-enabled smartphone and connect to the trainer pod to complete the power calibration by adjusting the resistance. FCC Warning: Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules.