Managed WiFi Power Plug with Switchable Relay Model: USP-Plug
Package Contents USP-Plug System Requirements • UniFi Network Controller software v5.13.5 or newer, available at: ui.
Hardware Overview LED 1 LED State Description Slowly Flashing Ready for setup, waiting to be paired Double Pulse Flashing Connecting to router Steady Blue (Always On) Powered on, connected to Wi-Fi Off Powered off, not plugged in
Button 2 Function Description Power Press and release the Button to toggle power on or off Factory Reset Press and hold the Button for five seconds or until the LED starts flashing
Before You Begin Hardware Installation 1.
2. 3. Wait for the LED on the Button to start flashing blue, and then launch the UniFi Network app. 4. Follow the on-screen instructions.
Specifications USP-Plug Dimensions Weight Max. Power Consumption Power Method Power Supply Supported Voltage Range Networking Interface Button Operating Frequency Max. TX Power Wi-Fi Standards Wireless Security Operating Temperature Operating Humidity Certifications ø50 x48 mm (ø1.97 x 1.89") 47 g (1.66 oz) 1100W for 110VAC AC Input AC/DC Embedded 100 - 240VAC, 50/60 Hz, Max. 10A 802.11 b/g/n Wi-Fi Power/Reset with Integrated LED 2.4 GHz 16.9 dBm (0.05W) 802.
Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in a location that can be submerged by water. WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning. Electrical Safety Information 1.
Limited Warranty ui.com/support/warranty/ The limited warranty requires the use of arbitration to resolve disputes on an individual basis, and, where applicable, specify arbitration instead of jury trials or class actions. Compliance FCC Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1.
ISED Canada CAN ICES-3(B)/NMB-3(B) This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: 1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause undesired operation of the device. This radio transmitter (IC: 6545A-USP1) has been approved by ISED Canada.
Online Resources Support help.ui.com Community community.ui.com Downloads downloads.ui.com Ubiquiti Inc. 685 Third Avenue, 27th Floor New York, NY 10017 USA ©2019 Ubiquiti Inc. All rights reserved. Ubiquiti, Ubiquiti Networks, the Ubiquiti U logo, the Ubiquiti beam logo, and UniFi are trademarks or registered trademarks of Ubiquiti Inc. in the United States and in other countries. Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries.