WIRELESS STEREO PANEL SPEAKER SYSTEM With Infrared Remote Control ARKON SP2990 Owner’s Manual (Preliminary)
INTRODUCTION The 900 MHz stereo wireless speaker system uses latest wireless technology that enables you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any audio source such as Radio, TV, VCR, Hi-Fi and CD/MP3/VCD/DVD player. Without complicated wiring and installation with your Audio/Video equipments and rear channel amplifier, the system enables you to enjoy thrilling, lifelike sound stereo in minutes. FEATURES 1.
INSTALLATION TRANSMITTER 1. Insert the antenna tube into the antenna wire. 2. Connect the supplied AC power adaptor to an electrical wall outlet. 3. Plug the AC power adaptor in the DC jack located on the rear of the transmitter. 4. The rear of the transmitter has one audio cord that can be connected to audio output jack of TV, Monitor, VCR, Radio recorder, CD/MP3/VCD/DVD players or to headphone/earphone jack with the connector provided.
5. Plug the adaptor in the AC source and the blue POWER LED will illuminate. If the blue POWER LED does not illuminate, make sure the adaptor is plugged in properly. SPEAKER RECEIVER 1. Insert 6 pieces ‘AA’ size ALKALINE battery into the battery compartment with correct polarity at the rear of the speaker or connect the 12V power adaptor to the DC input jack on the rear of each speaker, then plug it to the wall AC outlet. 2.
OPERATION 1. Turn on the audio source (TV or audio component) to which the transmitter is connected with. As soon as the transmitter is receiving the audio signal, the green SIGNAL LED will illuminate 2. Select the channel 1 or 2 of the transmitter for best performance in your location. 3. Press the + / - (volume level) button on the speaker and adjust the volume to the desired listening level.
4. Push the “SCAN” auto-tuning button on the speaker or Remote Control to get the best tuning reception. When the button is pressed, frequency tuning starts automatically and it stops when a signal is detected. A). Keep a distance of the speaker up to 7 meters apart from transmitter, and then press “SCAN” auto-tuning button for best tuning reception.
REMOTE CONTROL UNIT 1. Remove the battery cover at the rear of the remote control unit and insert 2 pieces “AAA” size batteries (included) into the battery compartment with the correct polarity. 2. Place back the cover and close the battery compartment Note You should now be able to place the speakers freely from room to room without disruption. If disruption should occur (signal breaks up), press the speaker’s “SCAN” auto-tuning button to maximize best reception.
2. Press the POWER button to turn off the speaker and the blue POWER LED light will goes off. If you use the remote control unit to turn off the speakers, the speakers will be at stand-by mode for 5 minutes and the LED will change from blue to yellow. You can switch on the speakers again by using the remote control unit during stand-by time. If there is no signal from the remote control unit for 5 minutes, the speakers will automatically power off.
SPECIFICATIONS Transmission Mode : UHF stereo Carrier Frequency : 900 MHz Operation Voltage : Transmitter, DC 12V 200mA (CH-1: 912.00 MHz / CH-2: 913.00 MHz) Speaker, 6 X ‘AA’ size Alkaline batteries (not included) or DC 12V 600mA adaptor Remote Control Unit, 2X ‘AAA’ size batteries (not included) Frequency Response : 20Hz - 13KHz Distortion : 1.