RF 900 MHz STEREO WIRELESS SPEAKER SYSTEM RS990 Owner's Manual Please read before using this equipment FCC ID: MVARS992-001R
INTRODUCTION The 900 MHz stereo wireless speaker system uses latest wireless technology that enable you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any sound source such as CD, TV VCR, Hi-F and radio. Without complicated wiring and installation with your and rear channel amplifier, the system enables you to enjoy thrilling, lifelike sound stereo in minutes. FEATURES 1. 900 MHz RF technology. 2.
TRANSMITTER SPEAKER RECEIVER BATTERY DOOR FCC ID: MVARSS92-001R WALL MOUNT HOLE ~DC INPUT 6V 600mA &-C0 POWER ON / SIGNAL INDICATOR (GREEN) FREQ. ADJUST AUDIO INPUT PLUG STEREO LED {5T.
INSTALLATION TRANSMITTER 1. Connect the supplied AC power adapter to an electrical wall outlet. 2. Plug the AC power adapter in the DC jack located on the rear of the transmitter. 3. The rear of the transmitter has one audio cord that can be connected to audio output jack of TV, TV monitor, VCR, CD, Radio tape recorder or to headphone/ earphone jack with the connector provided.
SPEAKER RECEIVER 1. Insert 4 pcs ‘D' size ALKALINE battery into the battery compartment with correct polarity at the rear of the speaker or plug the 6V 600mA power adapter {optional) into a wall outlet and connect to the DC input jack on the rear of the speaker. 2. Turn on the volume control and set to mid level at the front panel of the speaker. The power / stand-by indicator light up at same time. When the transmitter tum off, the receiver will auto mute at stand-by status. OPERATION 1.
c) Follow process {a) when making frequency adjustment for best stereo reception. Note: You should now be able to place the speaker freely from room to room without disruption. If disruption should occur (signal breaks up), adjust the speaker's tuning control to maximize stereo reception. If you hear interference from other components, re-adjust the tuning control of transmitter, and then the speakers to other free location. You can re-adjust the tuning control by moving it either right or left.
TROUBLE SHOOTING NO SOUND Ensure the AC adapter is fully inserted into the AC outlet and into the power connection input on the transmitter. Ensure the speaker's OFFEND switch is in the ON position. Speaker's battery may be too low. Ensure the TV or audit component is on and tuned to a channel with audio. Adjust the volume control on the speaker to tum up the volume. The connected audio/video equipment is not playing. Start playing the equipment.
SPECIFICATION Transmission Mode : UHF stereo ~ Carrier Frequency ~~ : 900 MHz Operation Voltage: : Transmitter, 19V 200mA : Speaker, BY {8 x'D' size Alkaline batteries) 6V 600mA adapter (optional) * Frequency Response : 20Hz-15KHz Distortion : 1.5% S/N ratio > 60dB Separation : 30dB Operation distance : 50M Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.