RF 900 MHz .
INTRODUCTION Tha 800 MHz stereo wireless speaker system uses latest wireless technology that enable you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any sound source such as CD, TV VCR, Hi-F, VCD, DVD and radio. Without complicated wiring and installation with your and rear channel amplifier, the system enables you to enjoy shilling, lifelike sound stereo in minutes. FEATURES 1. 800 MHz FF technology. 2.
INSTALLATION TRANSMITTER 1. insert the antenna tube into the antenna wire. 2. Connect the supplied AC power adapter to an electrical wall outset. 3. Plug the AC power adapter in the DC jack located on the rear of the transmitter. 4. The rear of the transmitter has one audio cord that can be connected to audio output jack of TV, TV monitor, VCR, CD, Radio tape recorder or to headphone / earphone jack with the connector provided.
SPEAKER RECEIVER 1. Insert pieces’ AA'size ALKALINE battery into the battery compartment with comment polarity at the rear of the speaker or plug the 12V 450mA power adapter Into a wall outset and connect to the DC input jack on the rear of the speakers. 2. Turn on the volume control and set to mid level at the front panel of the speakers, The power on indicator will light up at the mass time. OPERATION 1. Tum on the audio source {TV or audio component) to which the transmitter Is connected with. 2.
ec} Fallow process {a) when making frequency adjustment for best stereo reception. Veo 8) Note: You should now be able to place the speakers freely from rom to room without disruption. If disruption should occur {signal breaks up), adjust the speaker's tuning control fo maximize stereo reception. if you hear interference from other components, switch the channel control of transmitter, and then the speakers lo other free location.
TROUBLE SHOOTING NO SOUND DISTORTED Ensure the AC adapter is fully inserted into the AC outlet and the power connection input on the transmitter, Ensure the speaker is ON. Speaker's battery may be too low. Ensure the TV or audio component is ON and tuned fo a channel with audio output. Adjust the volume control on the speakers to an appropriate level. The connected audio / video equipment Is not playing. Start playing the equipment.
SPECIFICATION Transmission Mode Cartier Frequency Operation Voltage: Frequency Response : Distortion BIN ratio Separation Operation distance UHF stereo : 900MHz © Transmitter, DC19Y 100mA Speaker, DC 9¥ (6x AA'size Alkalizing batteries) or DC12V 450 mA adapter KHz 15% © 60dB 1 30dB 1 50M Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.