RF 900 MHz STEREO WIRELESS HEADPHONE SYSTEM WITH AUTO TUNING Owner’s Manual Please read before using this equipment
INTRODUCTION The S00MHz stereo wireless headphone stem with compact design uses latest wireless technology that enable you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any sound source such as CD, TV, VCR, Hi-F and radio. FEATURES 1. 900 MHz RF technology. 2. RF technology lets you roam frailly throughout your house. 3. Operating distance up io 50 Meters, 4. No line-of-sight limitation. 5. Rechargeable headphones receiver. 8.
TRANSMITTER CHARGE INDICATOR (RED) POWER SIGNAL CONTRAINDICATE) FREQ.
I INSTALLATION TRANSMITTER 1. Screw In the antenna on the transmitter. 2. Connect the supplied AC power adapter 10 an electrical wall outset. 3. Plug the AC power adapter in the DC jack located on the rear of the transmitter, 4. The rear of the transmitter has one audio cord that cen be connected to audio output jack Hi-F, VOR, Radio tape recorder or to headphone / earphone jack with the connector provided.
OPERATION 1. Turn on the audio source (TV or audio component) to which the transmitter is connected. 2. Switch the ON/OFF switch on the headphone to ON. © Place the headphones an your head and adjust the volume control to the desired listening level. > Press the Auto Tuning button of headphone url to the frequency which is same as transmitter's transmission frequency for best reception. The gran LED will light at this status. .
Note: You should now be able to walk freely from room to roam without disruption. If disruption should occur (signal breaks up), press Auto “Tuning button to maximize store reception. If you hear interference from other components, re-adjust the piquancy by pressing the Auto Tuning button. You may have to iry e few locations fo find one with no Interference.
CHARGING THE BATTERIES 1. Switch the ON/OFF switch on the headphone receiver to OFF. 2. Plug the charge output jack into the charge input socket of the headphone receiver to charge the batteries. 3. The charging process starts automatically when the batteries are charged and the RED LED light up, Charge the new batteries for 24 hours prior to the first use of the headphone system. Caution : Don't use other kind of battery to replace the rechargeable (AAA) battery.
SPECIFICATION Transmission Mode : UHF stereo Carrier Frequency : 8115-9135 MHz Operation Voltage Transmitter, 12V 300mA : Receiver, 2.4V (2 x AAA rechargeable battery) Frequency Response : 20Hz kHz Distortion 115% SIN ratio © 5048 Separation 1 20dB Operation distance: 50M “Operation is subject 1o the flowing two conditions: (1) this device may not cause interference, and(2) this device must accept any interference, including interference that may cause undesired operation of the device.
TROUBLE SHOOTING NO SOUND Ensure the AC adapter Is fully inserted info the AC outlet and into the power connection input on the transmitter. « Ensure the headphones’ ON/OFF switch is In the ON position. « Headphone's battery may be too low. Charge battery. Charge the new batteries for 24 hours prior to ihe first use, Ensure the TV, Hi-F or audio component is ON and tuned to a channel with audio. « Adjust the volume control on the headphone to tum up the volume.