User's Manual

GL2RF9_User_Manual_r1 2022-02-14
Page 1 of 7
GL2RF9 User Manual
1) FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
2) FCC Part 15 Clause 15.21:
“Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment”
3) FCC Part 15.19(a) [interference compliance statement],:-
“This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.”
4) ISED RSS-Gen Notice:
“This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two
conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.”
“Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.”
5) ISED Canada ICES-003 Compliance Label (CAN BE PROVIDED ON LABEL OR in MANUAL):
“CAN ICES-3 (B)/NMB-3(B)”
6) RF Exposure Guidance
In order to comply with FCC / ISED RF Exposure requirements, this device must be installed to provide at least 20
cm separation from the human body at all times.
“Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit être installé pour fournir au moins
20 cm de séparation du corps humain en tout temps. “
7) ANTENNA
The GL2RF9 is designed to be used with the following antenna,
a) A Dipole 2.1 dBi.
b) A Yagi 12dBi.
8) Host Manufacturers – must provide a physical label with the following information
Contains FCC ID: 2A3JY2RF9
Contains IC:28118-2RF9.