Instructions / Assembly

620 W. Warner Ave. • Santa Ana, CA 92707
Phone [phone]
Fax [phone]
www.rubbercal.com • www.ducting.com
FLEXIBLE INDUSTRIAL HOSE
& DUCTING
1. Determine length of duct needed. Allow extra
length for bends and joints.
2. Stretch duct fully from end to end, measure,
and mark desired length.
3. If any cutting is needed, determine the required
length and then cut completely around and
through duct with knife or scissors. Cut wire
with wire cutters
4. Slideoneendoftheductoverttingandpast
the bead.
5. Sealducttottingwithhoseclampplacedover
the ducting.
1. Determine length of duct needed. Allow extra
length for bends and joints.
2. Stretch duct fully from end to end, measure,
and mark desired length.
3. If any cutting is needed, determine the required
length and then cut completely around and
through duct with knife or scissors. Cut wire
with wire cutters
4. Slideoneendoftheductoverttingandpast
the bead.
5. Sealducttottingwithhoseclampplacedover
the ducting.
Connecting Duct to Outlet/Fitting
Connecting Two or More Ducts
Installation Requirements