Instructions / Assembly

Wire

strippers

Ladder

Safety

glasses

Electrical

tape

Phillips

screwdriver

PliersFlat blade

screwdriver

CAUTION

◆ Inspect the wire insulation for any cuts,

abrasions, or exposed copper that may have

resulted during shipping. If there is a defect

in the wire, do not attempt installation.

◆ Before starting installation of this ﬁxture or

removal of a previous ﬁxture, disconnect the

power by turning oﬀ the circuit breaker or by

removing the fuse at the fuse box.

Bulbs

(not included)

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED

EXPLODED PARTS INSTALLATION

STEP 2

Use the mounting screws to attach the mounting unit

to the junction box(not included).

STEP 1

Unscrew the mounting unit, rubber rings and screws

from the ﬁxture.

HARDWARE INCLUDED

Fixture

Screws

Mounting Screws

Wire Nuts

Mounting Unit

Rubber Rings

PAGE 1
ASSEMBLY INSTRUCTIONS CAUTION ◆ Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation. ◆ Before starting installation of this ﬁxture or removal of a previous ﬁxture, disconnect the power by turning oﬀ the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
ASSEMBLY INSTRUCTIONS (INSTALLATION) STEP 3 Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.