RFID CARD READER USER MANUAL HBK-D01
1.Warm Tips 1)Confirm the voltage (12VDC) and differentiate positive anode and cathode of the power supply. 2)About the wiring between the reader and the controller, the wire should be 22 AWG at least and the length should not exceed 100 meters. 3)When external power is used, suggest to use same power GND with controller panel. It is recommended to use multi-strand twisted pair cable to connect card reader to access controller.
5. Wiring Definiti Color Functionality Description Red +12V +12V power input Black GND GND Green D0 Wiegand output D0 White D1 Wiegand output D1 Blue LED LED signal feedback Yellow BEEP Buzzer signal feedback Gray Wiegand 34bits Optional Note: If the output format of the card reader you want is Wiegand 34bits, please connect the Gray wire and the Black wire together. 6.
Remarks: The card reader will prompt sound and light indication only when the LED and BEEP cables are connected to the access controller. 8. Wiring Diagram 9.
FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.