User Manual Enterprise Gateway GEE810U-915U
GEE810U-915U 1. Introduction Enterprise LoRa indoor gateway is designed to meet the needs of IoT services. This Enterprise indoor gateway allow the users to setup this in indoor environment as an aggregator of LoRa sensors to the internet for the related services. 2. Hardware Specifications Item Technical Information Processor Cortex A8 Storage/Memory 8GB eMMC/ 4Gb DDR3 LoRa 863-869.65 MHz WiFi IEEE 802.11 b/g/n 2.4 GHz Ethernet 10/100/1000 Mbps/ RJ45 Interface USB 2.
GEE810U-915U 3.2 Setup Quick Guide 3.2.1 Wall Mount & Ceiling Mount Installation Support This product provides the wall mounting support. For this function, 2 sets of tapping screws & expansion pipes in accessories should be used. I/O Port cables can be at upward or downward direction. 3.2.2 USB Dongle (not included) 3.
GEE810U-915U WLAN Constant Light Blue Wifi AP is enabled. LPWAN Constant off LoRa radio is off. ( ret= -1 in the radioparams.txt ) LPWAN Constant Light Blue LoRa radio is on. ( ret= 0 in the radioparams.txt ) 4. Software Setup 4.1 Use web interface to setup LoRa Indoor GW under Ethernet DHCP client mode ( Defult Primary WAN type ) 4.1.1 Plug in Ethernet cable in GW and the other end of cable should plug into where is DHCP server existing. 4.1.2 Power up Indoor GW. 4.1.
GEE810U-915U FW Version – HW Revision – Wan Status – Display current FW version Display current HW reversion (should not change) Display current backhaul connection state in the following format: , or NO (if WAN connection is not ready) Forwarding – “bs_pkt_fwd” process is running. “bs_pkt_fwd” forwards RF packets receive by the concentrator to a server through a IP/UDP link, and emits RF packets that are sent by the server. The default value: pkt_fwd_start=false (Disable).
GEE810U-915U 4.2.1 Select “Ethernet” as WAN 4.2.1.1 Use DHCP Mode to get IP address automatically A. Set Primary WAN type as “Ethernet” B. Set Ethernet IP Type under Ethernet Settings as “DHCP” C. Press Apply button 4.2.1.2 A. B. C. Use static IP Mode Set Primary WAN type as “Ethernet” Set Ethernet IP Type under Ethernet Settings as “Static” Configure proper settings in IP address / Netmask / Gateway / Primary DNS / Secondary DNS under Static IP Settings D. Press Apply button 4.
GEE810U-915U 4.4 Management Page Firmware Upgrade Before performing FW upgrade, please check the Status page for current firmware version. You need to be aware that only firmware for the same production could be used. Using invalid firmware or firmware from other products will get a “FW Upgrade Fail” message. The firmware file usually has a name in following format: PCG020C_[Date Code]_TI1003TP Where [Date Code] is the release date of this firmware.
GEE810U-915U View log in web browser The Filter command controls a simple content filter in log, you may enter keyword (case sensitive) to it, and only a line contained such keyword will be displayed. If keyword contained white space, double quota (“) must be used around the whole keyword. You will still need to enter (“”) in Filter command to display full log without filtering. Then, press [Apply] button and the log content will be displayed below.
GEE810U-915U Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
