UBTECH Sensor-controlled safety sign USER MANUAL Sensor-controlled safety sign USER MANUAL UBTECH ROBOTICS CORP LTD
UBTECH Sensor-controlled safety sign USER MANUAL CONTENT CONTENT..........................................................................................................................................2 Introduction........................................................................................................................................ 3 Part 1 Product Overview................................................................................................................. 4 1.1 Package List.
UBTECH Sensor-controlled safety sign USER MANUAL Introduction ◆ Thank you for purchasing Sensor-controlled safety sign equipment from UBTECH ROBOTICS CORP LTD. This user manual is only applicable to the operation of Sensorcontrolled safety sign. ◆ In order to ensure safe use of Sensor-controlled safety sign and quickly grasp the usage method, please read this manual carefully. ◆ Children under 12 years old should use this product under the guidance of adults.
UBTECH Sensor-controlled safety sign USER MANUAL Part 1 Product Overview 1.1 Package List • UVC Sensor-controlled safety sign (Door Sensor) *1 • User manual *1 NOTE: • Sensor-controlled safety sign use AA battery *8 1.
UBTECH Sensor-controlled safety sign USER MANUAL • Back:Power On button、Mode button • Side:Battery cover 1.3 System Framework Part 2 Safety Information Please read the following information carefully, the company will not be responsible for direct or indirect losses caused by improper use of the product. Note: To ensure safety, it is strongly recommended that users follow the following safety regulations when operating the robot. This manual does not guarantee to cover all possible situations.
UBTECH Sensor-controlled safety sign USER MANUAL 2.1 Device Security 2.1.1 General If you have no experience in operating Sensor-controlled safety sign, you need to be especially careful. Because you may not be familiar with Sensor-controlled safety sign operation at first. Do not use robots to implement operations related to personal safety. 2.1.2 Operation Instruction Danger If there is no emergency, it is recommended not to touch it while ADIBOT is performing its task.
UBTECH Sensor-controlled safety sign USER MANUAL If Sensor-controlled safety sign works abnormally, especially when you detect unusual sounds, smells or smoke, please take precautions and immediately turn off the power, remove the battery, and contact the technical support center.
UBTECH Sensor-controlled safety sign USER MANUAL Intrusion detection 4 5 Sensorcontrolled safety sign State Indicator Bluetooth pairing for example safety, fault and son on If any intrusion is detected through the movement and dumping of Sensor-controlled safety signs, the equipment shall be informed to stop disinfect in time Through the LED or buzzer to indicate the status of the Sensor-controlled safety sign itself, such as pairing, low power, etc Bluetooth pairing feature on Web 4.
UBTECH Sensor-controlled safety sign USER MANUAL the disinfection equipment will be informed in time to stop disinfect.
UBTECH Sensor-controlled safety sign USER MANUAL meters, which can block a conventional room door (such as hotel or hospital room door) Users can upgrade firmware via Bluetooth OTA • Pairing steps of Sensor-controlled safety sign: • When it is not paired, it will prompt "there is no pairing Sensor-controlled safety sign" Find the Bluetooth device and list the devices that can be found after searching for a period of time Note: the Bluetooth MAC address is pasted on the body of the caution for user iden
UBTECH Sensor-controlled safety sign USER MANUAL long time. It is found that there is no indication after the Sensor-controlled safety sign is opened. Please make sure that the battery has power. Part 6 Reference 6.1 Device Specification Dimensions Size 524(L) * 322(W) * 752(H) mm Weight 2.
UBTECH Sensor-controlled safety sign USER MANUAL activated -Check whether the battery socket in the control box is loose, abnormal or insufficient; -If the problem persists, please contact product technical support center. Sensor-controlled safety sign connection failed -The distance between entrance guard and disinfection equipment is too far. You can try to shorten the distance or add multiple Sensor-controlled safety signs. Part 7 Declaration of Conformity 7.