Wideband Location System Modular Tag V3.1 (UBIMOD31) User’s Manual Written By Andy Ward Ubisense Limited St Andrew’s House St Andrew’s Road Chesterton Cambridge CB4 1DL ENGLAND Tel: Fax: +44 (0)1223 535 170 +44 (0)1223 535 167 Email: WWW: support@ubisense.net http://www.ubisense.
Released: January 2019 Table of Contents Introduction ...................................................................................................................................... 1 Regulatory Information for the United States of America ................................................................ 1 Regulatory Information for Europe .................................................................................................. 2 Regulatory Information for Canada ............................
1 Introduction The Modular Tag V3.1 (model number UBIMOD31) is a wireless module intended to be integrated into other devices for the real-time location of objects. It transmits wideband pulses which are picked up by a network of basestations (Ubisensors), allowing the 3D position of the tag to be found. The use of wideband technology enables greater positioning accuracy within buildings than other wireless technologies, because it is much less susceptible to multipath interference effects.
2 Regulatory Information for Europe Hereby, Ubisense Limited declares that the radio equipment type Modular Tag V3.1 (UBIMOD31) is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.ubisense.net or from: Ubisense St. Andrew's House St.
3 and to ensure continued compliance with ISED standards and requirements once the module is installed within the host device. Il est de la responsabilité du fabricant du produit recevant le module dans son équipement, que ce dernier soit correctement étiqueté avec le texte suivant: Contains IC: 8673A-MOD31 Afin d’assurer la continuité de conformité avec les normes et les exigences de l’ISED, une fois le module installé dans l’équipement/le produit.
4 Integration information The dimensions of the module PCB are shown below: Ub 24.5mm 20mm 24.5mm ise ns e 20mm 2.1mm 4.5mm 1.6mm 3mm When mounting the tag on another device care must be taken to avoid occlusion of the antennas by tall components, shielding, or mounting screws. There should be an air gap of at least 1mm left around both of the antennas to avoid detuning. While the connector provides some mechanical fixing it is not recommended that this is the only fixing point.