VoIP Phone with 5" HD LCD and Touch Model: UVP-Touch
Package Contents UniFi VoIP Phone Touch Installation Requirements • UniFi Switch or PoE+ (802.
Camera Built-in camera can be used for snapping photos for avatars or videoconferencing applications. Touchscreen The touchscreen display is used for all interface navigation and dialing. Keypad Touch to display the numeric keypad. Volume Use the volume arrows to adjust audio levels. LED The LED will illuminate when the device is first connected to a 48V power source. Once the phone has started up, the LED will turn off. IMPORTANT: The LED will flash when a firmware update is occurring.
PoE/LAN The PoE/LAN Ethernet port is 802.3at-compliant and is used to connect data and power to the phone. Connect this port to the same network as the UniFi Security Gateway VOIP port. PC The Ethernet port labeled PC is used for bridging. WARNING: Do not connect a powered Ethernet connection to the port labeled PC. Side Ports USB C Port The USB C port can be used to charge a device. Headset Jack 3.5 mm jack for optional wired stereo and microphone headsets.
Handset Mute button Mute Press the Mute button to mute the microphone on the handset. Hardware Installation 1.
2. PoE/LAN PC Configuration Enter the SIP server address, username, and password.
Making a Call Lift the handset to make a call and the keypad will appear. Use the Delete button to correct any mistakes. Press the Call button to make a call.
Call Manager Connected Number Displays the extension or phone number that is being dialed or that is currently connected. Volume Slider Use the slider to increase or decrease the volume level. Connection Status Displays “Dialing” or the total elapsed time of the currently connected call. Mute Mute the microphone so that audio is not broadcast. Hold Place the caller on hold. Hold music will be played. Add Call Press to add another call for a group conversation.
Specifications UVP-Touch Dimensions 166 x 140 x 182.5 mm (6.50 x 5.50 x 7.19") Weight 1.10 kg (2.43 lbs) Display 5" (Diagonal), 720 x 1280 HD, G+F Multi-Touch Camera 5M Pixel LED Handset Audio Codec Power Status: White, Glowing Dynamic Receiver 16 ohm/SPL 116dB @1KHz, 30mW, 0m Omnidirectional Electret Microphone/SNR 70 dB/Sensitivity -38 ± 3 dB WCD9326: standalone Hi-Fi audio codec IC WSA8815: Smart Speaker Amplifier Power Input Hands-Free Speaker Hands-Free Microphone Connectivity PoE+ 802.3.
Important Warning Regarding Emergency Calls NOTE THAT THE LIMITATIONS SET FORTH BELOW ARE APPLICABLE TO ALL EMERGENCY CALLS, FUNCTIONS AND SERVICES, INCLUDING 911, ENHANCED 911 AND 112 CALLS (COLLECTIVELY, “EMERGENCY SERVICES”). 1. You should be aware that: a. Emergency Services may not connect to the Public Service Answering Point (“PSAP”), or may ring to the administrative line of the PSAP, which may not be staffed after hours, or by trained emergency operators. b.
Safety Notices 1. 2. 3. Read, follow, and keep these instructions. Heed all warnings. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. Electrical Safety Information 1. 2. 3. Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label.
Compliance FCC Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
ISED Canada CAN ICES-3(B)/NMB-3(B) To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: 1. This device may not cause interference, and 2.
RF Exposure Warning The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter. Les antennes utilisées pour ce transmetteur doivent être installé en considérant une distance de séparation de toute personnes d'au moins 20 cm et ne doivent pas être localisé ou utilisé en conflit avec tout autre antenne ou transmetteur.
English European Directive 2012/19/EU requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams. It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by the government or local authorities.
territoriales. L’élimination et le recyclage en bonne et due forme ont pour but de lutter contre l’impact néfaste potentiel de ce type de produits sur l’environnement et la santé publique. Pour plus d’informations sur le mode d’élimination de votre ancien équipement, veuillez prendre contact avec les pouvoirs publics locaux, le service de traitement des déchets, ou l’endroit où vous avez acheté le produit.
Ελληνική [Greek] Δια του παρόντος, UBIQUITI NETWORKS, δηλώνει ότι αυτή η συσκευή UBIQUITI NETWORKS, είναι σε συμμόρφωση με τις βασικές απαιτήσεις και τις λοιπές σχετικές διατάξεις των οδηγιών 2014/53/ΕE. Magyar [Hungarian] Ezennel UBIQUITI NETWORKS kijelenti, hogy ez a UBIQUITI NETWORKS készülék megfelel az alapvető követelményeknek és más vonatkozó 2014/53/EU irányelvek rendelkezéseit.
Online Resources Support support.ubnt.com Community community.ubnt.com Downloads downloads.ubnt.com www.ubnt.com ©2019 Ubiquiti Networks, Inc. All rights reserved. Ubiquiti, Ubiquiti Networks, the Ubiquiti U logo, the Ubiquiti beam logo, and UniFi are trademarks or registered trademarks of Ubiquiti Networks, Inc. in the United States and in other countries. Google, Android, Google Play and other marks are trademarks of Google Inc. All other trademarks are the property of their respective owners.