Quick Start Guide

ManualsBrandsUbiquiti ManualsElectronicsBullet

Bullet AC IP67 N-Type Right Angle Adapter

Package Contents

Installation Requirements

Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor

wired Ethernet connections and should be grounded through the AC ground of the

PoE.

We recommend that you protect your networks from harmful outdoor environments

and destructive ESD events with industrial-grade, shielded Ethernet cable from

Ubiquiti. For more details, visit ui.com/toughcable

Surge protection should be used for all outdoor installations. We recommend that

you use two Ethernet Surge Protectors, model ETH-SP, one near the Bullet and the

other at the entry point to the building. The ETH-SP will absorb power surges and

safely discharge them into the ground.

* Shown without antenna.

Hardware Overview

BulletAC-IP67 Quick Start Guide

Summary of content (11 pages)

PAGE 1
BulletAC-IP67 Quick Start Guide Package Contents Bullet AC IP67 N-Type Right Angle Adapter Installation Requirements Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor wired Ethernet connections and should be grounded through the AC ground of the PoE. We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. For more details, visit ui.
PAGE 2
BulletAC-IP67 Quick Start Guide Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. Ethernet Port This 10/100/1000 Ethernet port is used to connect the power and should be connected to the LAN and DHCP server. Hardware Installation 1. 2.
PAGE 3
BulletAC-IP67 Quick Start Guide 3. 4. 5.
PAGE 4
6. 7. 8.
PAGE 5
BulletAC-IP67 Quick Start Guide Note: The Bullet should be mounted vertically to reduce stress on the N-Type Connector. The N-Type Right Angle Adapter may be used as needed. Accessing airOS via Wi-Fi Verify connectivity in the airOS® Configuration Interface using the UNMS™ app or Web Portal. Both are available for 15 minutes immediately after you power on the device. If necessary, you can power cycle the device to re-enable its Wi-Fi. UNMS App 1. Download the UNMS app. 2.
PAGE 6
3. Launch the app and follow the on-screen instructions. BulletAC-IP67 Quick Start Guide Web Portal 1. Connect your device’s Wi-Fi to the SSID named: : Note: Ensure that your Wi-Fi connection has DHCP enabled. 2. Launch your web browser and go to: http://setup.ui.com 3. Select your Country and Language. You must agree to the Terms of Use to use the product. Click Continue. 4. Create a username and password. Confirm your new password and then click Save.
PAGE 7
The airOS Configuration Interface will appear, allowing you to customize your settings BulletAC-IP67 Quick Start Guide as needed. For additional details, refer to the User Guide available at ui.com/download/airmax-ac Installer Compliance Responsibility Devices must be professionally installed and it is the professional installer’s responsibility to make sure the device is operated within local country regulatory requirements. Antenna Select your antenna from the list.
PAGE 8
BulletAC-IP67 BulletAC-IP67 Quick Start Guide Dimensions 190 x 46 mm (7.72 x 1.81") Weight 213 g (7.51 oz) Enclosure Aluminum and Rubber Processor MIPS 74KC Memory DDR2 64MB Networking Interface (1) 10/100/1000 Ethernet Port Antenna Connector N-Type Connector Max. Power Consumption 7W Max. TX Power 22 dBm Power Supply 24VDC, 0.3A (Minimum)* Power Method 24V Passive PoE (Pairs 4, 5+; 7, 8 Return) Shock and Vibration ETSI300-019-1.
PAGE 9
2. There are no operator serviceable parts inside this equipment. Service should be provided only BulletAC-IP67 Quick Start Guide by a qualified service technician. Limited Warranty ui.com/support/warranty The limited warranty requires the use of arbitration to resolve disputes on an individual basis, and, where applicable, specify arbitration instead of jury trials or class actions.
PAGE 10
This equipment complies with radiation exposure limits set forth for an uncontrolled BulletAC-IP67 Quick Start Guide environment. This equipment should be installed and operated with minimum distance 256 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.