60 GHz/5 GHz Radio System with 1 Gbps+ Throughput Model: 60G-Link
Package Contents 60G Link Metal Strap Ball Joint Mount Gigabit PoE (24V, 0.
Installation Requirements • Pole-mounting: 7 mm socket wrench or screwdriver • Wall-mounting: wall fastener (not included) • Shielded Category 5 (or above) cabling with drain wire should be used for all wired Ethernet connections and should be grounded through the AC ground of the PoE. We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial‑grade, shielded Ethernet cable from Ubiquiti. For more details, visit ui.
Hardware Overview 1 Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. Alternatively, the device may be reset remotely via a Reset button located on the bottom of the Gigabit PoE Adapter. 2 Ethernet Port This Gigabit Ethernet port is used to connect the power and should be connected to the LAN and DHCP server.
LEDs 3 4 5 6 7 3 GPS Lights steady blue when there is a strong GPS signal. . 4 60 GHz Lights steady blue when 60G link is ready. 5 5 GHz Lights steady blue when the 5 GHz link is ready. 6 LAN The LED will light steady blue when an active Ethernet connection is made to the Ethernet port and flash when there is activity. 7 Power/Status Color Status Flashing White Bootup is in progress. White Ready for use; UNMS is disabled. Blue Ready for use; UNMS is enabled and connected.
Hardware Installation Go to the appropriate mounting instructions: Pole Mounting or “Wall Mounting”. Pole-Mounting 1. 2.
3. 4.
Wall Mounting The device must be mounted directly to a wood stud or other structurally stable surface to avoid damage to the mounting hole when you adjust the aim. Optional Accessory To enhance stability, you can use the NanoBeam® Wall Mount Kit, model NBE-WMK (sold separately). Note: Center screw included. Two optional screws (not included) provide additional stability. Installation Instructions 1.
2. 3. OR Fastener (not included) 4.
Aiming 1. 2.
Connecting Power 1. 2.
3. 4. Connect the power using: • included Gigabit PoE Adapter • PoE switch WARNING: The switch port must comply with the power specifications listed in the Specifications section of this Quick Start Guide.
Accessing airOS via Wi-Fi Verify connectivity in the airOS Configuration Interface using the UNMS™ app or Web Portal. Both are available for 15 minutes immediately after you power on the device. If necessary, you can power cycle the device to re-enable its Wi-Fi. UNMS App 1. Download the UNMS app. 2. Connect your device’s Wi-Fi to the SSID named: 60G-Link: Note: Ensure that DHCP is enabled on your Wi‑Fi adapter. 3. Launch the app and follow the on-screen instructions. Web Portal 1.
3. Select your Country and Language. You must agree to the Terms of Use to use the product. Click Continue. 4. Create a username and password. Confirm your new password and then click Save. The airOS Configuration Interface will appear, allowing you to customize your settings as needed. For additional details, refer to the User Guide available at ui.
Installer Compliance Responsibility Devices must be professionally installed and it is the professional installer’s responsibility to make sure the device is operated within local country regulatory requirements. The Output Power field is provided to the professional installer to assist in meeting regulatory requirements.
Specifications 60G-Link Dimensions 140 x 140 x 90 mm (5.51 x 5.51 x 3.54") Weight 376 g (13.3 oz) Gain 5 GHz 60 GHz 10 dBi 17.2 dBi Networking Interface 10/100/1000 Ethernet Ports Wi-Fi for Management Enclosure UV-Resistant Polycarbonate Max. Power Consumption Power Supply 11W 24V, 0.5A Gigabit PoE Adapter (Included) 24V, 1A if Using Motor Accessory Power Method Passive PoE (Pairs 4, 5+; 7, 8-) Wind Loading 56 N @ 200 km/h (12.
Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in a location that can be submerged by water. WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning. Electrical Safety Information 1. Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label.
Compliance FCC Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE: Radiation Exposure Statement: • This equipment complies with radiation exposure limits set forth for an uncontrolled environment. • This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body. • This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
CE Marking CE marking on this product represents the product is in compliance with all directives that are applicable to it. Country List AT BE BG CY CZ DE DK EE IE IT LV LT EL ES FI LU MT NL PL PT RO SE FR HR HU SI SK UK BFWA (Broadband Fixed Wireless Access) members noted in blue Note: This device meets Max. TX power limit per ETSI regulations.
Deutsch Die Europäische Richtlinie 2012/19/EU verlangt, dass technische Ausrüstung, die direkt am Gerät und/oder an der Verpackung mit diesem Symbol versehen ist, nicht zusammen mit unsortiertem Gemeindeabfall entsorgt werden darf. Das Symbol weist darauf hin, dass das Produkt von regulärem Haushaltmüll getrennt entsorgt werden sollte.
Italiano La direttiva europea 2012/19/UE richiede che le apparecchiature contrassegnate con questo simbolo sul prodotto e/o sull’imballaggio non siano smaltite insieme ai rifiuti urbani non differenziati. Il simbolo indica che questo prodotto non deve essere smaltito insieme ai normali rifiuti domestici.
Français [French] Par la présente UBIQUITI déclare que l’appareil 60G-Link, est conforme aux exigences essentielles et aux autres dispositions pertinentes des directives 2014/53/UE, 2014/30/UE, 2014/35/UE. Le texte complet de la déclaration UE de conformité est disponible à l’adresse internet suivante: ui.
Slovenščina [Slovenian] Družba UBIQUITI izjavlja, da je naprava 60G-Link v skladu z obveznimi zahtevami in drugimi ustreznimi določbami direktiv 2014/53/EU, 2014/30/EU in 2014/35/EU. Celotno besedilo izjave EU o skladnosti je na voljo na naslednjem spletnem naslovu: ui.