Preface Rugged Tablet PC User Manual
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Canada, Industry Canada (IC) Notices This Class B digital apparatus complies with Canadian ICES-003 and RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Radio Frequency (RF) Exposure Information The radiated output power of the Wireless Device is below the Industry Canada (IC) radio frequency exposure limits.
Exploring Your T10C Tablet Before starting to set up the T10C, get familiar with the locations and purposes of controls, connectors and ports, which are illustrated in the figures below. When placed upright on the desktop, the front panel of the T10C appears as shown in below. The front side of the T10C is equipped the I/O as described below.
1. Power LED Indicator 2. Storage Access 3. Wireless ON/OFF Power LED Indicator Letting you know that system is turned on and indicate the battery charging status.
battery is embedded with the system with fully charged, and there is no 2nd optional battery installed in the system. If the system installs both the 1st internal battery and 2nd optional battery, the illustration shown below indicates its current charging status and capacity. If 1st battery capacity drops to 15%, the system will display the following warning message for 5 seconds. For RF status: The following RF status shows you that the system is equipped with Wi‐Fi, and Bluetooth functions.
For System Information: The system information shown on the left shows you the utility version, BIOS and EC version and you can use them for customer service when asked. Using the Application Your T10C has numbers of applications on the control panel for executing specific command. It provides you to adjust brightness, volume, launch webcam, and switch monitor (via docking). Brightness Control For brightness adjustment, press the Brightness icon.
When you press it, the Volume control panel is appeared as follows: You can click incrementally. or to reduce or increase the audio volume Also, you can slide the scale bar You can tick the Mute to set the audio volume. to mute the audio. Launch Webcam Utility For Webcam Launch, press the Webcam Or can access the Webcam icon to launch the Webcam utility. icon located on desktop.
Do not puncture or disassemble the battery. Do not attempt to open or service the battery. Replace only with batteries designed specifically for this product. Keep the battery out of reach of children. Dispose of used batteries according to local regulations. Maintaining the LCD Display Only operate touch panel using a polyacetal stylus pen (tip R0.8 mm or more) or a finger. Do not scratch the surface of the screen with any hard objects.
