2-IN-1 Snap On module UG
- ININ - 1SNAP ON MODULE User Guid e FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
2 - ININ - 1SNAP ON MODULE User Guid e Europe – EU Declaration of Conformity This device complies with the essential requirements of the R&TTE Directive 1999/5/EC and EMC directive 2004/108/EC.
2 - ININ - 1SNAP ON MODULE User Guid e Specification The 2-IN-1SNAP ON MODULE is a flexible, With following specifications that can be applied in diverse operational environments and implemented in multi-faceted applications. Barcode Scanner : < Decoded Mode : 1D Symbologies : EAN/UPC, RSS, Code 39, Code 128, UCC/EAN 128, ISBN, ISBT, Interleaved, Matrix, Industrial and Standard 2 of 5, Codabar, Code 93/93i, Code 11, MSI, Plessey, Telepen, postal codes.
2 - ININ - 1SNAP ON MODULE User Guid e GPS : '- ISO/IEC 14443A, 14443B, 15693 - Mifare 1K/4K, Ultralight - NFC-IP1 Protocol 5
2 - ININ - 1SNAP ON MODULE User Guid e Using a Barcode Scanner /GPS Module The System provides barcode scanner/GPS functions for your optional selection, before installing either of these two modules on the top side of the system, please remove the screws previously (illustrated in the following graphics as indicated step 1). To install the Barcode Scanner/GPS Module: 1. Make sure the system is turned off. Unscrew four screws from the accessory door on top of the system. 2.
2 - ININ - 1SNAP ON MODULE User Guid e 3. Insert FFC cable of barcode scanner into connector slot or attached the GPS cable to the connectors on the daughter board. 4. Screw to secure the Barcode Scanner/GPS onto the tablet. GPS: 1). Set baud rate to 9600bps 2).
2 - ININ - 1SNAP ON MODULE User Guid e COM port# corresponding to 1st set of "Silicon Labs Dual CP210x USB to UART Bridge: “Enhanced” COM Port (COMx) Using a NFC /GPS Module The System provides NFC/GPS functions for your optional selection, before installing either of these two modules on the top side of the system, please remove the screws previously (illustrated in the following graphics as indicated step 1).
2 - ININ - 1SNAP ON MODULE User Guid e 5. Make sure the system is turned off. Unscrew four screws from the accessory door on top of the system. 6. Mount and secure the Daughter board into the mainboard with screws. 7. Insert FFC cable of barcode scanner into connector slot or attached the NFC/GPS cable to the connectors on the daughter board. 8. Screw to secure the NFC/GPS onto the tablet. 9.
2 - ININ - 1SNAP ON MODULE User Guid e 9.1. The shape and size of the RFID tag. Large Size RFID tags have longer read range (Smaller tags have a smaller RF radiating field) 9.2. Any metallic objects near the RFID tag will effectively reduce the read range 9.3. Any electrical interference from surrounding electrical equipment may reduce read range.
2 - ININ - 1SNAP ON MODULE User Guid e 9. Make sure the system is turned off. Unscrew four screws from the accessory door on top of the system. 10. Mount and secure the Daughter board into the mainboard with screws. 11. Insert FFC cable of barcode scanner into connector slot or attached the CAC/GPS cable to the connectors on the daughter board. 12. Screw to secure the CAC/GPS onto the tablet.