UBC1319AA00 DOCSIS 3.
UBC1319AA00 Quick Installation Guide D3.0 Wireless eMTA Subscriber • SAFETY NOTICES Grounding the Device: Install the cable modem to include grounding the coaxial cable to the earth as close as practical to the building entrance per ANSI/NFPA 70 and the National Electrical Code (NEC, in particular, Section 820.93, Grounding of the Outer Conductive Shield of a Coaxial Cable). The device is designed for IT power systems with phase-to-phase voltage at 120V.
UBC1319AA00 Quick Installation Guide • DEVICE WALL MOUNT INSTRUCTIONS You can mount the UBC1319AA00 on a wall by following the steps below: 1. You will need 4 round or pan head screws with the following measurements: Label Millimeters (mm) A 7.2 +/- 0.5 B 2.6 +/- 0.15 C 19.0 +/- 1.2 D 3~4 5. Separate the wall mounting pieces. Mount the top and bottom leg stand pieces (Figure 1) onto the UBC1319AA00 as shown in Figure 2. 6.
UBC1319AA00 Quick Installation Guide • DEVICE CONNECTIONS AND BUTTONS RESET: To reset the device, take a small object like the end of a paper clip and insert it into the RESET opening. To power cycle the device, hold for less than 5 seconds. To reset to factory default settings, hold for more than 5 seconds. WARNING: Resetting factory defaults will erase ALL settings that you have made and will restore the device to factory default settings. TEL: Connects an analog telephone using an RJ11 cable.
UBC1319AA00 Quick Installation Guide • LED BEHAVIOR LED Normal State Normal State Faulty/Alarm State (LED ECO Mode Enabled) (LED ECO Mode is Automatically Disabled) FRONT PANEL DS/US (downstream/ upstream) ON Solid White OFF Blinks White = Problem on the network and device cannot link properly INTERNET ON Solid White OFF Blinks White = CPE fails to obtain IP address WPS Blinks White = WPS button is pushed OFF N/A OFF Blinks White = WiFi initialization issue OFF Blinks White = eMTA regi
UBC1319AA00 Quick Installation Guide • FEDERAL COMMUNICATION COMMISSION (FCC) INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.