USER’SMANUAL DVW3213B BCM3380Z D3.
目錄 1. Introduction ............................................................................................................................ 3 1.1 Scope ................................................................................................................................ 3 1.2 Function ............................................................................................................................ 3 2 Product Specification..............................................................
Section One: Introduction 1. Introduction Project Name: BCM3380Z D3.0 Wireless eMTA. The typical use model for this embedded device is to allow the client device to be connected to an 802.11b/g/n 2x2 wireless network with infrastructure mode or to serve as an ad-hoc (peer-to-peer) data path. 1.1 Scope The Wireless BCM43224 is an available 11n solution in the 2.4GHz band, compatible with the IEEE 802.11b/g/n. The 802.11 g data rate provides for 54, 48, 36, 24, 18, 12, 9, 6Mbps, and 802.
2 Product Specification 2.1 Hardware Specification Wireless LAN Standards IEEE 802.11 b/g/n Operating Frequency 2400~2483.5MHz WLAN Data Rate 802.11g: 54Mbps with fall back of 48, 36, 24, 18, 12, 9, 6Mbps. 802.11b: 11Mbps with fall back rates of 5.5, 2, and1Mbps 11n: MCS8~MCS15 Transmitter Output Power Typical 15.5dBm(AV) for 11b Typical 15.5dBm(AV) for 11g Typical 14.5dBm(AV) for HT20 Typical 13.
3. Product Requirements 3.1 Hardware Requirements Host Interface PCI-E 3.2 Hardware Architecture This specification describes an embedded 802.11b/g/n WiFi interface PCA ‘module’ for embedded device products. The module has two antennae. This module is powered from the host (3.3V) and interfaces to the host with PCIE-half signals. No switches, indicators or related user interface signals are provided on this module. An on-board 20 MHz XTAL is included.
I/O PIN DEFINE 6
4 FCC Notice Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID:XCNC210400C”.