User's Manual

GR-309 Door/Window Detector
Introduction
Thanks for choosing the Door/Window detector for your Z-Wave home automation. The GR-309 is
a Z-Wave Binary sensor, it works with any Z-Wave compliant gateway or controller. !
Specifications
!
!
Protocol: Z-Wave!
Frequency: 868.42MHz (EU) / 908.42MHz (US) !
Code Type Learning: Yes!
Transceiver: Yes!
Operating Range: Up to 100 feet!
LED Indication: Yes
!
Installation:
!
!
Notice: If you are installing the entire Z-WaveTM system for the first time, please refer to
the installation guide of Z-WaveTM Interface Controller before installing
1. Unscrew the screw fastening the rear cover.
2. Slide the rear cover down.
3. Using the screws or adhesive tape to affix the rear cover on the frame along the !
opening edge of door / window.
4. Insert 2xAAA battery into the battery compartment and LED will start to flash
slowly, which means the sensor has not yet been “inclusion”. The sensor belongs to categ
5. For“Inclusion”in (adding to) a network: Put the Z-Wave TM Interface Controller
into “inclusion” mode, and following its instruction to add the GR-309 to your
controller. To get in the “inclusion” mode, the distance between sensor and
controller is suggested to be in one meter. Press the program switch of GR-309 for
1 second at least. The LED on the GR-309 should go solid, if not, please try again.
!
Operating ambient temperature range:-20 to 40 and the power supply is 1.5v AAA x2.
The sensor belongs to category 3 receiver, and the dutycycle is less than 0.01 in a period 1 hour.
U-Fairy G.R. IOT Tech CO., Ltd.