User's Manual

GR-105 Operating Instructions
Introduction
Thanks for choosing the auto valve for your Z-Wave home automation. The GR-105 is a Z-
Wave auto valve, it works with any Z-Wave compliant gateway or controller. It can open/close the
water valve
Specifications
Type：GR-105
Power：DC 12V/1A
Z-wave Frequency：868.42MHz (EU)/908.42 MHz (US)
Operating Range：Up to 100 feet line of sight
Twist pressure：1.6Mpa
Resist twisting：30~60kg.cm
Package content：DC 12V/1A、hardware fitting
Installation：
1. Inclusion/ Exclusion Z-Wave network
Put the Z-Wave interface controller into “inclusion or exclusion” mode, and press the red
power button once, the distance between GR-105 and controller is suggested to be in one
meter.
2. For pipeline valves, the original ball as far as possible the total households in the ease of
design and installation manual position. The Valve control should be installed in the original
total gas ball valve. The Case not close to the wall, the wall should be a palm distance (20mm)
above the installation.
3. Due to power outages, testing, maintenance, security and other needs，It can be close the
valve by manually：Robot with finger in ring-pull down the clutch, do not release your finger
and hold, 90 degree turn the handle, manual open and close the valve, Until the handle on/off
to the correct position.
cautions：
The sensor belongs to category 3 receiver, and the dutycycle is less than 0.01 in a period 1 hour.
Operating ambient temperature range:-20℃ to 40℃ and the power supply by adapter.
Adapter shall be installed near the equipment and shall be easily accessible. The plug considered
as disconnect device of adapter,
The adapter Manufacturer: Shenzhen CSEC Co.,Ltd.
Model No.: CS12F120100FGF
INPUT: 100V-~240V~ 50/60Hz 500mA
OUPUT: 12V/1.0A
DECLARATION OF CONFORMITY:
Hereby, U-Fairy G.R. IOT Tech CO.,Ltd declares that this Auto valve product is in compliance
with the essential requirements and other relevant provisions of Directive 1999/5/EC.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
U-Fairy G.R. IOT Tech CO., Ltd