Use Instructions

Apple Watch Charging cable
Net Weight：38.7g Length: 1.2M
Specification：
Made for：
Model：AW-LOOPMBK-T/AW-LOOPMBL-T
AW-LOOPMBK-TC/AW-LOOPMBL-TC
Model Name: Apple Watch Charging cable
Input: 5V/1A
Working environment：-10℃-+50℃
Output: 5V/1A
Apple Watch Series 4
Apple Watch Series 3
Apple Watch Series 2
Apple Watch Series 1
Use Instructions:
● Install the Apple Watch magnetic charging cable into
your dock.
● Connect the USB connector to 5V USB power.
● Place the Apple Watch on the magnetic module surface
while charging, kindly take off case before that.
● Battery icon displays on the screen indicating charging
status
PHOTOGRAPH OF THE PRODUCT
PVC
Wireless output
USB input
FCC Information
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC ID: 2AOAF-910