User's Manual

ManualsBrandsTyco Safety Products/Sensormatic ManualsElectronics15.247 WIRELESS LR-WPAN IN 2.4 GHz BAND USING DIGITAL SS.

ZBAMB4300 SYNC ACCESS POINT 8200-0958-03, REV. 2B

INSTALLATION GUIDE

1 of 7

ZBAMB4300

Sync Access Point

Installation Guide for Lowe’s

Hardware Stores

The ZBAMB4300 Sync Access Point (Sync AP) is

an AC line zero-crossing detector that can transmit

zero crossing data to nearby ZBAMB2070 Mobile

Handheld Deactivators to prevent detection

interference with nearby EAS detectors.

This guide explains only how to install the Sync AP

in a Lowe’s hardware store. For setup instructions,

see ZBAMB4300 Sync AP Connection and Setup

Guide 8200-0958-06.

If you need assistance...

Contact your Sales Representative.

Summary of content (7 pages)

PAGE 1
ZBAMB4300 Sync Access Point Installation Guide for Lowe’s® Hardware Stores The ZBAMB4300 Sync Access Point (Sync AP) is an AC line zero-crossing detector that can transmit zero crossing data to nearby ZBAMB2070 Mobile Handheld Deactivators to prevent detection interference with nearby EAS detectors. This guide explains only how to install the Sync AP in a Lowe’s hardware store. For setup instructions, see ZBAMB4300 Sync AP Connection and Setup Guide 8200-0958-06. If you need assistance...
PAGE 2
Installation Locations On the wall near the main or lumber entrance In the Universal Outdoor Enclosure near the garden center entrance. OR ZBAMB4300 SYNC ACCESS POINT INSTALLATION GUIDE 8200-0958-03, REV.
PAGE 3
Safety Parts Required Supplied WARNING: Part  Install the AP in an air space not used for environmental air. DO NOT install it in a plenum or other environmental air-handling space.  Cables placed in environmental airspace must be plenum rated unless the cables are in raceways. Qty. Part Number Power Supply Module* 1 5606-0079-01 Install Kit (indoor install only) 1 0352-0580-01 Connector, Female, RJ45 1 2109-0717-01 Cable, Cat5, 4.
PAGE 4
Installation A: Main/Lumber Entrance 4 For the garden center entrance, see Installation B. Electrical Connection Points 3.7M (12FT) FROM FLOOR 5 The electrical connections near the EAS system are generally the same, but may vary from store to store. A typical scenario is described below. Power Cable Route The power cable route goes from: Alarm Module  The AC outlet inside the main electrical box in which the power supply module (1) and femaleto-female coupler (2) reside.
PAGE 5
Installation B: Garden Center Entrance For the main/lumber entrance, see Installation A. Electrical Connection Points The location of electrical connection points near the EAS system is generally the same for each store, but details may vary from store to store. These instructions cover a typical scenario. Sync AP Mounting Location Mount the Sync AP in the Universal Outdoor Enclosure.
PAGE 6
Specifications Declarations Electrical Regulatory Information AC input ........................................ 100–240V @ 47-63Hz FCC ID: BVCAMB43 DC Input ................................................... 18Vdc @ 1.7A NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 7
Other Declarations WARRANTY DISCLAIMER: Sensormatic Electronics, LLC makes no representation or warranty with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. Further, Sensormatic Electronics, LLC reserves the right to revise this publication and make changes from time to time in the content hereof without obligation of Sensormatic Electronics, LLC to notify any person of such revision or changes.