EXHIBIT C User Manual
UNINTERRUPTIBLE POWER SUPPLY USER MANUAL STARTUPS LITE 500 REV 1.
User Manual Power UPS 500 Dear Customer, Congratulations on having made an intelligent choice. This product is designed and manufactured with utmost care to give you high quality trouble-free performance in the years to come. Please register your product by filling the enclosed Business Reply Card and Mailing it to us. This will enable you to avail free warranty services, in the unlikely requirement of any service assistance.
TVS ELECTRONICS LIMITED HARDWARE WARRANTY What the warranty covers TVS Electronics Limited, warrants the buyer, that its hardware product sold is free from defective workmanship or material under normal use and service. If a product proves to be defective in material or workmanship during the warranty period, we will at our sole option repair or replace the product with a like product. How long is the warranty Power UPS 500 is warranted for 3 years without battery for all manufacturing defects.
User Manual Power UPS We thank you for selecting a TVSE Uninterruptible Power Supply (UPS) and recommend that you read these instructions carefully before installation and start-up of the Power UPS 500. Please keep this manual in a safe place for future reference. Contents 1. Introduction ....................................................................... 6 2. Safety................................................................................ 7 3. Outlook And Function ...........................
1 Introduction The Power UPS will help you to protect your sensitive equipment like computers and telecommunication installations against malfunctioning due to non-reliable or distorted mains/ utility/line - voltage This modern, microprocessor controlled UPS protects the connected equipment against Surges, Sags, Spikes, etc. by means of an internal filter that works all the time.
2 Safety This UPS can be operated by anyone, without any special training, after reading this manual WARNING: RISK OF ELECTRICAL SHOCK: HIGH-VOLTAGE AND HIGH-CURRENT CIRCUITS INSIDE, even if disconnected from the mains voltage Do not remove cover, no user serviceable parts inside Refer servicing to qualified service personnel CAUTION: THIS EQUIPMENT MUST BE EARTHED AT ALL TIMES WHILST IN USE Replace batteries only with the same type and rating Disconnect batteries during maintenance Do not dispose the bat
3. Outlook And Function 3.1 Front panel LINE BAT.
St at u s Ev en t UPS ON Battery Co n d it io n Red /Gr een Red /Yello w L ED1 L ED2 Bu zzer Res et Bu zzer - - Yellow ON continuous Beeps 1x4 Sec. Pressing ON button Battery low A l a r m s t a r t s w he n b a t t e r y voltage is 10.5V DC and the unit s hall t r ip at 10V DC. The UPS s ho ul d no t g e t O N w he n t he Battery voltage is less than 10V - Yellow ON continuos Beeps 1x2 Sec.
3.2 Rear Panel To modem DB 9 port (Serial port) LAN/FAX/MODEM surge protect From Telephone line OUT IN UPS output without Power back-up UPS output with Power back-up Input Power cable Rating Label Resettable fuse Fuse thermal 5A. StartUPS LITE Fuse used is a resettable 5A. Reset the fuse in case it is open.
4. Installation 4.1 Inspection Inspect the UPS upon receipt. Notify the carrier and dealer if there is damage. The packaging is recyclable; save it for re-use or dispose of it properly. 4.2 Placement Install the UPS in a protected area with adequate air flow and free of excessive dust. Do not operate the UPS if the temperature and humidity are not within the specified limits. In colder territories allow the UPS to come to room temperature before operating. 4.
5. Operation 5.1 To reset the UPS microprocessor, in case of an unknown situation: With the UPS unplugged from the wall outlet, press the OFF button for 2 sec. This will reset the internal microprocessor. 5.2 Turn off UPS Output Power To turn off the UPS’s output power, press the OFF button longer than 2 sec. 5.3 Turn on UPS Output Power Press the ON button 2 sec to switch the UPS on and to supply power to the loads.
6. Alarms 6.1 On Battery During on-battery operation, the on-BAT Led comes on and the UPS gives an audible alarm consisting of one beep every 4 seconds. The alarm stops when the UPS returns to on-line operation. Press the ON button during on-battery operation to stop the beeping. This mutes the current alarm only, the next on-battery alarm will be audible. Shutting off the audible alarm in this way does not affect the computer interface alarm. 6.
7. Specifications Input frequency Input voltage window Output frequency Output voltage mains mode Output voltage inverter mode Wave form Transfer time Power factor Battery type Recharge time : : : : : : : : : : Temperature : Relative humidity : 50 ±5 Hz 140-300V AC 50Hz ± 0.1 Hz in battery mode 190-255V 230V±5% output load variation of 0-100% Quasi sine wave 4msec typical 0.
8. On-Battery Run Time Table Typical battery backup time: run time (in minutes) as a function of load L o ad VA/Wat t s B ac k u p t i m e Typical UPS load (75%) 7 100/60 33 300/180 10 500/300 4.5 After ‘End Autonomy’ automatic restart possible during 8 hours.
9. Trouble shooting P r o b l em U P S w i l l no t t ur n on.
P r o b l em P o s s i b l e C au s e U P S b uzze r ha s constant tone, and UPS overloaded m a i n s vo l t a g e i s present So l u t i o n Remove the excessive load U P S b uzze r ha s R e m o ve m a i ns p o w e r constant tone, and UPS overloaded or short cord Push ’OFF’ button for m a i ns vo l t a g e i s circuit in battery mode 2 se c. not present C ha rg e the b a tte ry. The U P S ’ s b a t t e r y r e q ui r e s re c ha rg i ng a fte r a n extened outage.
10 About the Battery 1. Life of the battery depends on operating temperature and on the number of discharge cycles. 2. “WHEN DOES THE BATTERY NEED REPLACING?” If the BAT Led on the front of the UPS flashes 1x30sec and buzzer sounds, it implies that the battery will no longer hold a full charge. Under this circumstances, if a power failure occurs, the UPS runs less than half its normal length of time when compared to a good battery.
12 Storage Store the UPS covered and placed upright in a cool place, with its battery fully charged. Before storing charge the batteries for at least 24 hours. Disconnect any cables connected to the computer interface port to avoid unnecessarily draining the battery. Make sure that the UPS is switched off. Storing the unit for longer than 3 months can reduce the life of the batteries. To maintain the normal life expectancy, recharge the battery. For chargeing the battery refer section 4.7.
SafeWare Program: Each time the Windows 95 program is started , SafeWare for windows 95 will automatically start and run unless the user deletes the SafeWare Icon from the Windows 95 Startup folder. By default, SafeWare will start in “Minimized” mode. Once the SafeWare application has been closed, clicking on the SafeWare icon in either the SafeWare folder or the Startup folder will once again start SafeWare.
of the chart can be used to view different time periods. They include:Current View, Previous View, Previous Page, Next Page, Scan Left and Scan right. The waveform information can be viewed at any time and will continue to be updated as long as SafeWare is running. however, if the user terminates the SafeWare program, all waveform information will be erased unless the user has recorded the information using the Recode button located under the Toggle Waveform button.
13. Frequently asked questions: Q:What is the warranty of the UPS? A: One year on the Battery, Three years on the unit, against registration of the unit. Q:Where can I get UPS serviced? A:UPS required to be carry-in to the nearest TVS-E Authorised Service Provider for serviceing. Q:What is the life of the battery? A:Battery life is 3-5 years depending on the usuage.It depends on the operating temperature and number of discharge cycles.
How to get Service As soon as the installation is completed, you are requested to fill up the Warranty Registration Card. to get your name registered with us. To avail warranty service, please contact the nearest TVS-E Authorised Dealer/Authorised service centre/Regional office. While registering your call, please mention/produce (a) Serial no. of the unit (b) date of purchase as mentioned in the invoice of the product. (c) The problem you are facing with the unit d) Your Tel. no./FAX no.
TVS ELECTRONICS LIMITED Plot No.34. Developed plots, South phase, Industrial estate Guindy Chennai-600 032. Visit us at www.tvse.
Copyright & Regulatory Information This manual and software described in it are copyrighted with all rights reserved. This manual may not be copied, in whole or in part, without written consent. All product names are trademarks and or registered trademarks of their respective companies. FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.