Tools Needed For Models : 6736205 Adjustable Wrench Groove Joint Puller « Phillips Screwdriver « Silicone Sealant « Teflon Tape Tangier Single Handle Bathroom Faucet Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft, damp cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and void your warranty.
Parts Diagram / List Part Name 1 Handle 2 Set Screw 3 Handle Button 4 Trim Cap 5 Lock Nut é Cartridge 7 Flow Re stricter 8 O-ring 9 Cartridge Seat 10 O-ring 1 Spout 12 Body 13 O-ring 14 Screw 15 Screw 16 Metal Washer 17 Lock Nut 18 ©O-ring 19 Copper Tube 20 Screen Aerator 21 Copper Tube 22 Deck Plate 23 Gasket 24 Allen Key 25 Racket Wrench 26 Screen Filter 27 Pop-up Assembly 28 Knob 29 O-ring 30 Lift Rod 31 Stopper 32 Threaded End 33 Washer 34 Washer & Lack Nut 35 Pop-up Body 36 Ball Rod 37 Ball Nut 38 Spri
Preparation/Assembly 1. Shut off the water supplies before installation. Remove the current faucet, clean and dry the sink surface the new faucet well be Installed on. 2. Attach deck plate (#22) and gasket (#23) onto the body 3. Apply Teflon tape on the threads of faucet cold & hot water supply tubes in a clockwise direction. 4. Place silicone sealant beneath the faucet body (#12) and install the faucet through the single faucet hole. Attach metal washer (#16) and lock nut (#17) from the bottom.
Installation Instructions 5. Slip 2" coupling nuts onto water supply tubes or use flexible stainless steel supply lines (recommended) both are sold separately. To avoid breaking the copper tube on the faucet, use two wrenches (as shown) to keep from twisting the supply tube from the faucet when you tighten the nut. Typically the cold water supply is on the = right and the hot water supply is on the left. Water Supply Hoses 6.
Installation Instructions Sep 10-15 Have a question? DON'T GO BACK TO THE STORE, WE CAN HELP, . Insert drain stopper (#31) into the drain. On the “7T underside of the sink, ensure the ball nut (#37) i is on the stopper ball rod (#36) before you insert into the pop-up body ensure the rod is Inserted through the drain stopper base hole. See diagram for visual.
Trouble-Shooting If you've followed the Instructions carefully and your faucet still does not work properly, take these connective steps. Problem Cause Acton Leaks underneath handle. Lock nut (#5) has come loose. Tighten the lock nut Remove handle (#1) and cartridge {#6} to check if ceramic disk is damaged permanently or dirty.