Turning Technologies RCRF-03 ResponseCard RF LCD and RRRF-03 USB HID RF Receiver User’s Manual RCRF-03 & RRRF-03 User’s Manual Ver.
Overview: The RCRF-03 Keypad is designed to be used with the RRRF-03 Receiver connected to a PC. The keypad transmits key presses via radio frequency to the RF receiver for accumulation by the PC. The keypad consists of 12 data keys (0-9, Channel, ?), a single status LED, and a small LCD. ResponseCard RF LCD (RCRF-03) The ResponseCard RF LCD keypad is handheld designed to send responses over RF to a receiver. In Idle state, the LED and LCD are OFF.
Quick Yellow Blink then OFF/LCD with Circle with SlashReceiver is not accepting data at this time Blinking Yellow - key is being transmitted (up to 8 seconds) Solid Green/LCD with Response pressed - key transmit successful - ready for input Solid Red/LCD with Ch and Slash- key transmit failed – ready for input Blinking Green/LCD with Response pressed - Receiver indicated correct answer Blinking Red - Receiver indicated incorrect answer Blinking Green and Blinking Red will only occur if the Receiver is confi
HID RF Receiver (RRRF-03) The RRRF-03 needs to be plugged into a USB port on a computer to ensure proper operation. Once the RRRF-03 is plugged in and recognized by the operating system, the appropriate software from Turning Technologies must be launched to enable the polling solution. Additionally, the RRRF-03 has the ability of a mass storage device once recognized by the operating system.
REGULATORY INFORMATION FCC Statement This product has been tested and found to comply with Part 15 of the FCC Rules. Operation it subject to the following conditions: it may not cause harmful interference and must be accept interference received, including interference that may cause undesired operations. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.