User's Manual

ManualsBrandsTurning Technologies ManualsElectronicsResponseCard RF LCD

Replace batteries With Maxell, CR2032, 3-Volt

Coin Cell ONLY. Use of another battery may

present risk of fire or explosion.

The disposal of used batteries is governed by law in

many countries world-wide. Therefore, please

check your local regulations prior to battery

disposal.

Responsive Innovations

ResponseCard RF LCD

User’s Manual

RCRF-03 User’s Manual Ver. Preliminary

Summary of content (4 pages)

PAGE 1
Replace batteries With Maxell, CR2032, 3-Volt Coin Cell ONLY. Use of another battery may present risk of fire or explosion. Responsive Innovations The disposal of used batteries is governed by law in many countries world-wide. Therefore, please check your local regulations prior to battery disposal. ResponseCard RF LCD User’s Manual RCRF-03 User’s Manual Ver.
PAGE 2
REGULATORY INFORMATION FCC Statement This product has been tested and found to comply with Part 15 of the FCC Rules. Operation it subject to the following conditions: it may not cause harmful interference and must be accept interference received, including interference that may cause undesired operations. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PAGE 3
pressed. Valid keys are ‘0’ through ‘9’. Valid RF Channels are ‘1’ through ‘82’. While in Set RF Channel mode pressing a valid key will cause the status LED to briefly flash YELLOW. When Set RF Channel Mode exits, the status LED indicates the result as follows: SOLID GREEN RF Channel successful SOLID RED RF Channel failed - Set Overview: The RI RF LCD Keypad is designed to be used with the RI RF Receiver connected to a PC.
PAGE 4
Blinking Green and Blinking Red will only occur if the Receiver is configured to indicate a correct or incorrect answer (CORRECT POLLING mode). Setup Modes: Active at any time the keyboard is ready for input. Match Mode (Check RF connection) Press ‘?’ In order for Match Mode to operate properly an RF Receiver MUST also be placed into Match Mode.