951 MANUAL PORTABLE AIR CONDITIONER Model: Cree and GLADIOLI SMART Before using TURBO Portable get aE eT manual carefully and retain i for future forbearance.
www.turbro.com Tips for First-Time Use 1. Allow the unit to sit upright for at least 3-4 hours before powering on. Shipping carriers may set the unit on its side, which causes the refrigerant to pool in certain areas. Standing the unit upright for 3-4 hours allows the refrigerant to move freely within the coils. 2. Some parts with sharp edges may cause injury, so gloves are highly recommended for unpacking and installing. 3.
www.turbro.com CONTENTS SAFETY INFORMATION: cox cesserseessesersssessersseesses assess senselessness eases assess o1 PARTS DESCRIPTION: mantas assess stasis east 03 INSTALLATION INSTRUCTIONS Installation Location-Tool Suggested -. Installing In Double-Hung Sash / Sliding Casement Windows Installing Exhaust Hose OPERATING INSTRUCTIONS Control Panel Operating from the Control Panel Operating from the Remote Control Operating from the APP. Self-diagnosis «recuses Water Drainage Methods. .
www.turbro.com FEY INFORMATION Please read all instructions before use and save this user manual for future reference. A digital version can be obtained from Customer Support. Your safety and the safety of others are very important to us. We have provided many important safety messages throughout this manual and on the appliance itself Always read and follow all posted safety messages.
www.turbro.com @® This product should be plugged directly into a power outlet. Power outlets should be properly rated, protected, and sized in order to avoid electrical overload. Do not use a multiple-outlet power strip or extension cord. Failure to do so may result in short-circuit or electrical shock. @® Do not use an AC plug adapter with this appliance ® Do not cut or remove the third (ground) prong from the power cord BY °C @ Your air conditioner must be used in a properly grounded wall receptacle.
www.turbro.com A Gc If the TEST button does not cause the circuit breaker trip or the RESET button will not stay engaged, unplug alr conditioner Immediately and contact TURBO Customer Support. NOTE: : Do not use this device to turn the unit on or off. « Always make sure the reset button is pushed in for correct operation * The power cord must be replaced if it fails to reset when either the test button is pushed, or it cannot be reset. * If power supply cord is damaged, it cannot be repaired.
support@turbrocom wwwi.turbro.com Hose Inlet 0 ip Exhaust Hose 1st Hose Outlet TT Window Panel + Extension Panel 1st [amp] se vy Metal Locking Screw Adjustment Panel without Hole 1st Remote Control Battery 1st Drainage Hose 1st Foam Seal 1st [GE ETE] ETE ION IN ION @® The air conditioner should be placed on a firm floor to minimize noise and vibration.
support@turbrocom www.turbro.com LCL CT till pg head Se SE Dead sheave Sid TEE BEEN sign pend The window panel kit has been designed to fit most standard windows that open vertically or horizontally; however, it may be necessary for you to improvise/modify some aspect of the installation procedures for certain types of window. Minimum and maximum window openings: 2 59 Inches NOTE: If the width of your window is smaller than 20.
www.turbro.com ¢. Place the assembled window panels on the window sash and adjust until it fully covers the width of your window. henchmen Min D0 oil TTT 0 5@ inches Max. /9 inches Min. NN NOTE: If the width of your window is smaller than 20.5 inches, please remove the adjusting panel from the window panel and then cut the window panel to make the width of the window panel the same width as your window. d. Use the provided metal locking screws to secure the window panel kit. f.
www.turbro.com COOL & DEHUMIDIFY: Air exhaust hose should be connected to the portable air conditioner. FAN MODE: Air exhaust hose should be disconnected from the portable air conditioner. A. Required Parts: ® Hose Inlet @ Exhaust Hose ® Hose Outlet B. Assembly: a. Align both the arrows of the Hose Inlet connector and the Exhaust Hose, then rotate the Hose Inlet clockwise or counter-clockwise to lock into place. (see Fig. 1) b. Use the same way to attach the Hose Outlet and the Exhaust Hose, c. Fig.
support@turbrocom www.turbro.com oT Tier Bl High 8 wie ll Lew 8 auto 8 Q Timer Button (D Fan speed Button > Decrease Button Soon 8 Seen rn Bi ory QD Increase Button (D Mode Button (WIFI Resets (D offend Button Operating from the Control Panel The Control Panel enables you to manage all the main functions of the appliance, but to fully exploit its potential, you must use the remote control TURNING THE APPLIANCE ON @ Plug into the mains socket, then the appliance is in standby.
support@turbrocom wwwiturbro.com High To reach the desired temperature as rapidly as possible Low To operate under low noise Auto To run at a suitable fan speed automatically. NOTE: After reaching the set temperature, the compressor will stop working. Then the fan will work intermittently to help circulate air. When the temperature rises, the compressor will be back on.
www turboprop @® Press the Mode Button 2 until the ‘Auto’ indicator lights up. Also, the screen will display like below: ® Press the Fan Button #§ to select the fan speed: High / Low / Auto TIMER FUNCTION This timer can be used te delay the unit start up or shutdown, this avoids wasting electricity by optimizing operating periods. Programming start up @ Press the ON/OFF Button turn on the unit and choose your desired mode, for example ‘cooling, 68%F and high fan speed’.
www turboprop ow To turn on/off the air conditioner MODE | To select the operation mode. /N\ To increase the setting temperature; to lengthen the time in TIMER setting \ To decrease the setting temperature; to reduce the time in TIMER setting E To adjust the air flow direction vertically FAN To adjust the fan speed TURBO | To switch on/off the TURBO mode; to change the temperature scale TIMER | To switch on/off the TIMER function SLEEP | To switch on/off the SLEEP mode To activate the Child Lock, press and
www turboprop The following functions only can be active by using the remote: SWING FUNCTION C This function is useful for selecting the up/down swing of air circulation. /* \ ® Select the operating mode (Cool, Dry, Fan) as described above ® Press the Swing Button [E on the remote to control the deflector to swing automatically or not SLEEP FUNCTION This function is useful to use at night as it maintains the room at optimum temperature silently without excessive fluctuations in either temperature or humidit
www.turbro.com Inserting or replacing the batteries Remove the cover on the rear of the remote control Insert two "AAA" 1.5V batteries in the correct position (see instructions “we 3 inside the battery compartment) | / NOTE: ® If the remote control unit is replaced or disposed of, the batteries must be removed and discarded in accordance with current legislation as they are harmful te the environment. @® Do not mix old and new batteries.
www.turbro.com Self-Diagnosis This unit has a self diagnosis system to identify a number of malfunctions. Error messages will be displayed on the display screen. @ If this is displayed, contact TURBO service team PROBE FAILURE (sensor damaged) ® Empty the internal safety tank, following the instructions in the "WATER DRAINAGE METHODS” FULL TANK (safety tank full) Water Drainage Methods TURBO portable air conditioner comes with the auto-evaporation system. The unit can automatically evaporate the condensate.
www.turbro.com NOTE: If you find it hard to insert the hose, please use a hairdryer or some hot water to soften the drain hose before installation ec ned Fem Garden hose or drainage hose Beat esp NOTE: Please be sure that the height of and section of the drain hose should not be higher than that of the drain outlet, or the water tank may not be drained NOTE: In COOL mode and DRY made, the drainage hose is recommended to be connected to the middle drain port.
www.turbro.com EN HH LLL & a and & [ windows do not cover the appliance curtains CLEANING Before cleaning or maintenance, turn the appliance off and wait for a few minutes, then unplug from the electrical outlet Cleaning the Outer Case You should clean the appliance with a slightly damp cloth then dry with a dry cloth, ® Never wash the appliance with water. It could be dangerous @ Never use petrol, alcohol or solvents to clean the appliance. ® Never spray insecticide liquids or similar.
www.turbro.com Maintenance Checklists Pr-Season Maintenance Checklist @® Check the power cord for any cuts or exposed wiring @® Check the ground prong is still on your power plug. @® Clean the air filter. ® Check whether the hose adapters and exhaust hose are installed tightly and free of damage Post-Season Maintenance Checklist ® Disconnect unit from the power outlet @ Clean air filter and exterior case @® Drain any accumulated water from the air conditioner.
www.turbro.com Not cool A. The windows, doors and / or A. Make sure all the doors, windows and curtains enough curtains are not closed. are closed (Refer to ‘Tips for Correct Use’). B. There are heat sources inside B. Remove the heat sources if possible. the room (oven, hairdryer, etc.) C. Connect the air exhaust hoe and make sure C. The air exhaust hose is not it can function properly (Refer to ‘Installing connected or blocked the Air Exhaust Hose") D. The temperature is set too high D.
www.turbro.com WARRANTY & C MER SUPPORT WARRANT TURBO provides a 1-year limited warranty for TURBO products from the date of purchase, subject to the following conditions and limitations outlined below.
Cc CAN ICES-3 FCC Caution This device complies with part 15 of the FCC Rules.