Installation Instructions

ManualsBrandsTurboX ManualsElectronicsCalculation Module

Applicant/Grantee Thundercomm Technology Co., Ltd

FCC ID: 2AOHHTURBOXC6125

Section 15.212 Modular Transmitters

Request for Modular Approval Request for Limited Modular Approval

Requirements EUT Conditions

Comply (Y/N)

Single Modular Approval Requirements

1 The radio elements of the modular

transmitter must have their own

shielding. The physical crystal and

tuning capacitors may be located

external to the shielded radio elements.

The radio portion of this module is

shielded, please see exhibition external

photos.

2 The modular transmitter must have

buffered modulation/data inputs (if such

inputs are provided) to ensure that the

module will comply with Part 15

requirements under conditions of

excessive data rates or over-modulation.

The module has buffer modulation/data

inputs.

3 The modular transmitter must have its

own power supply regulation.

The module has its own power supply

regulation. Please see the schem.pdf

4 The modular transmitter must comply

with the antenna and transmission

system requirements of Sections 15.203,

15.204(b) and 15.204(c). The antenna

must either be permanently attached or

employ a “unique” antenna coupler (at

all connections between the module and

the antenna, including the cable). The

“professional installation” provision of

Section 15.203 is not applicable to

modules but can apply to limited

modular approvals under paragraph (b)

of this section.

The requirements of antenna connector

and spurious emission have been

fulfilled. Please refer to the Test Report

exhibition.

5 The modular transmitter must be tested

in a stand-alone configuration, i.e., the

module must not be inside another

device during testing for compliance

with Part 15 requirements. Unless the

transmitter module will be battery

powered, it must comply with the AC

line conducted requirements found in

Section 15.207. AC or DC power lines

and data input/output lines connected to

the module must not contain ferrites,

unless they will be marketed with the

module (see Section 15.27(a)). The

length of these lines shall be the length

typical of actual use or, if that length is

unknown, at least 10 centimeters to

insure that there is no coupling between

the case of the module and supporting

Please refer to the Setup Photo

exhibition for the stand-alone test

configuration.

Summary of content (3 pages)

PAGE 1
Applicant/Grantee FCC ID: Thundercomm Technology Co., Ltd 2AOHHTURBOXC6125 Section 15.212 Modular Transmitters Request for Modular Approval Request for Limited Modular Approval Requirements EUT Conditions Single Modular Approval Requirements 1 The radio elements of the modular The radio portion of this module is transmitter must have their own shielded, please see exhibition external shielding. The physical crystal and photos. tuning capacitors may be located external to the shielded radio elements.
PAGE 2
6 equipment. Any accessories, peripherals, or support equipment connected to the module during testing shall be unmodified and commercially available (see Section 15.31(i)). The modular transmitter must be equipped with either a permanently affixed label or must be capable of electronically displaying its FCC identification number.
PAGE 3
8 The modular transmitter must comply with any applicable RF exposure requirements in its final configuration. ____________________________ Contact Person: Qiyong Zhou E-mail: Zhouqy0710@thundersoft.com Please refer exhibition RF Exposure for the compliance of MPE RF exposure rule.