Empowering Every IoT Device with Our Technology Thundercomm Turbox™ SOM Datasheet Machine Type: CM450, C450, CM625, and C626. Rev. V1.
Thundercomm Turbox™ SOM Datasheet Revision History Revision Date Description 1.0 Feb 23, 2021 Initial release 1.1 May 06, 2021 Add Appendix 1. Statement and Compliance. Copyright© 2021 Thundercomm Technology Co., Ltd. All rights reserved.
Thundercomm Turbox™ SOM Datasheet Table List Table 1-1: Key features and performance of APQ8053 Pro/SDA450 processor Table 1-2: Key features and performance of C626/C450 SOM Table 2-1. Interface description list Table 2-2. Pin signal list Table 2-3. Pin list for power supply interface Table 2-4. Pin list for touch screen interface Table 2-5. Pin list for display interface Table 2-6. Pin list for camera interfaces Table 2-7. Pin list for audio interfaces Table 2-8. Pin list for USB interfaces Table 2-9.
Thundercomm TurboxTM SOM Datasheet Table of Contents Chapter 1. Introduction ................................................................................................................... - 2 - 1. Key features ...................................................................................................................................................... - 2 - 2. Hardware block diagram ............................................................................................................
Thundercomm TurboxTM SOM Datasheet Chapter 1. Introduction The C450 CM450 CM625 C626 is a high-performance SOM (Software on Module) based on the Qualcomm 626 (APQ8053Pro) platform. It brings high-value features to mid-tier devices, designed to support all-day battery life, enhanced camera, advanced graphics, and more. The ultra-compact form factor of the module can be fit into any mobile device such as translator,handheld pos and tablet.
Thundercomm TurboxTM SOM Datasheet RGMII Other Interfaces Not supported Charger Operating Environment 1x SDC for SD card 8x BLSP, be configured as 8x SPI or 8x I2C or 4x UART 2x camera dedicated I2Cs Not supported Operation Temperature: -20℃ ~ 70℃ Operation Humidity: 5%~95%, non-condensing Power supply 3.6V ~ 4.4V, typ. 3.8V Dimension 34.0 x 35.0x 3.0mm @295 pin RoHS All hardware components are fully compliant with EU RoHS 2.0 directive 2. Hardware block diagram Figure 1-1.
Thundercomm TurboxTM SOM Datasheet 3. Mechanical size The size of Turbox™ C626/450 SOM is 19mm x 16mm x 2.3mm, and you can check the size of BTB (board to bord) connectors through their datasheets. Figure 1-2. Chipset Overview 4.
Thundercomm TurboxTM SOM Datasheet Chapter 2. Interface Description This chapter introduces all the interfaces definition, aiming to help developer design and test Thundercomm Turbox C626 series SOM easily. 1. Interface parameter definitions Table 2-1. Interface description list Symbol Description AI Analog input AO Analog output B Bidirectional digital with CMOS input CSI Supply voltage for MIPI_CSI circuits and I/O; (1.
Thundercomm TurboxTM SOM Datasheet 2. Description Figure 2-1. Chipset Bottom View 3. Pin list Table 2-2. Pin signal list No. Signal No. Signal No.
Thundercomm TurboxTM SOM Datasheet No. Signal No. Signal No.
Thundercomm TurboxTM SOM Datasheet No. Signal No. Signal No.
Thundercomm TurboxTM SOM Datasheet No. Signal No. Signal 97 MIPI_DSI0_LANE3_N 197 VBAT_BB 98 GND 198 NC 99 LCD0_RST_N 199 NC 100 TP0_I2C_SDA 200 KEY_VOL_UP_N No. Signal 3.1. Power supply interface Table 2-3. Pin list for power supply interface PIN Name PIN Type Description VBAT_BB 195,196,197 PI Module power supply, 3.3 ~ 4.2V, nominal value 3.8V VPH_PWR 182,183,184 PO 4.2V output for external circuit VREG_L2_1P1 214 PO Reserved 1.
Thundercomm TurboxTM SOM Datasheet Pin Name IO Pin No.
Thundercomm TurboxTM SOM Datasheet MIPI_CSI0_LANE2_P AIO 11 MIPI camera serial interface 0 lane 2 – positive MIPI_CSI0_LANE3_N AIO 30 MIPI camera serial interface 0 lane 3 – negative MIPI_CSI0_LANE3_P AIO 31 MIPI camera serial interface 0 lane 3 – positive Camera2 Interface Pin Name IO Pin No.
Thundercomm TurboxTM SOM Datasheet Table 2-7. Pin list for audio interfaces SlimBus Interface (WCD9335) Pin Name IO Pin No.
Thundercomm TurboxTM SOM Datasheet Pin Name IO Pin No. instruction NC PI 205,206 USB_DM AI AO 209 USB2 high-speed data – minus USB_DP AI AO 210 USB2 high-speed data –plus USB_ID AI 154 USB 2.
Thundercomm TurboxTM SOM Datasheet Table 2-10. Pin list for UART interface Pin Name IO Pin No. instruction UART2_RXD DI 88 Receive Data UART2_TXD DO 104 Transmit Data UART4_RXD DI 139 Receive Data UART4_TXD DO 128 Transmit Data UART5_RXD DI 54 Receive Data UART5_TXD DO 66 Transmit Data UART5_CTS DI 61 Clear to Send UART5_RTS DO 55 Request to send NOTE: Turbox C626 SOM UART Level is 1.8V. Add level conversion IC when connecting peripherals.
Thundercomm TurboxTM SOM Datasheet Chapter 3. Function Description 1. Power supply sequence Figure 3-1.
Thundercomm TurboxTM SOM Datasheet 2. Power supply interface Dedicated PMIC (Power Management Integrated Circuit) continuously monitors events that might trigger a power-on sequence. If an event occurs, these circuits will power on the IC (Integrated Circuit), check and enable power sources for the device. Two methods to power on your device: Press the power-on key to power on the device, and wait for 3s to boot up the system.
Thundercomm TurboxTM SOM Datasheet Table 3-2. Reset interface definition PIN Name PM_RESIN_N PIN 155 Voltage Type pulled up internally to 1.8V Description Notes Volume down/Reset key signal, Low active DI 4. PWMs All PWM output are made by Light Pulse Generators. Independent programmable duty cycle and period via LPGs (6or 9-bit resolution) are for digital dimming. Table 3-3.
Thundercomm TurboxTM SOM Datasheet Chapter 4. Electrical Characteristics 1. Operating conditions Table 4-1. Power supply operating condition list Parameters Min Typical Max Units Input Power voltage USB_IN 3.8 VBATT, VPH_PWR +2.7 -30 6 V 3.8 +4.8 V 25 85 °C Thermal conditions Device operating temperature (case) 2. Power output Table 4-2. Power output parameters Function Default voltage(V) Programble range(V) Rated current(mA) Default State Expected use VREG_S1_0P8625 0.87 0.32–2.
Thundercomm TurboxTM SOM Datasheet Function Default voltage(V) Programble range(V) Rated current(mA) Default State Expected use VREG_L12_2P95 2.950 1.750–3.3375 50 ON MSM pad group 2 VREG_L13_3P075 3.125 1.750–3.3375 150 ON USB, external codec audio VREG_L14_UIM1 1.800 1.750–3.3375 50 Off UIM1 VREG_L15_UIM2 1.800 1.750–3.3375 50 Off UIM2 VREG_L16_1P8 1.800 1.750–3.3375 5 Off PMIC HKADC VREG_L17_2P85 2.850 1.750–3.3375 300 Off Camera and display VREG_L18_2P7 2.
Thundercomm TurboxTM SOM Datasheet 6. I2C interface Table 4-5: I2C standards and exceptions Applicable standard Feature exception I²C Specification, version 5.
Thundercomm TurboxTM SOM Datasheet Appendix 1. Statement and Compliance FCC statements: The device for operation in the band 5150–5350 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems. Federal Communication Commission (FCC) Radiation Exposure Statement When using the product, maintain a distance of 20cm from the body to ensure compliance with RF exposure requirements. This device complies with part 15 of the FCC rules.
Thundercomm TurboxTM SOM Datasheet The suitable temperature for the product and accessories is -20℃-70℃. RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure requirement, use product that maintain a 20cm distance between the device and human body.
Thundercomm TurboxTM SOM Datasheet Hardware version: TURBOX-C450_SOM Software version: 2020.10.22 Software version note:Some software updates will be released by the manufacturer to fix some bug or enhance some function after placing on the market. All versions released by the manufacturer have been verified and still compliance with the related rules. All RF parameters (e.g.: frequency range, output power) are not accessible to the user, and can’t be changed by the user.
Thundercomm TurboxTM SOM Datasheet Appendix 2. Notices Thundercomm may have patents or pending patent programs covering subject matter described in this document. The furnishing of this document does not give you any license to these patents. You can send license inquiries to service@thundercomm.com.
Thundercomm TurboxTM SOM Datasheet Appendix 3. Trademarks Thundercomm, Thundercomm Turbox, TURBOX, Thundersoft turbox are trademarks of Thundercomm Corporation or its associate companies in China and/or other countries. Intel, Intel SpeedStep, Optane, and Thunderbolt are trademarks of Intel Corporation or its subsidiaries in the U.S. and/or other countries. Microsoft, Windows, Direct3D, BitLocker, and Cortana are trademarks of the Microsoft group of companies.
