Installation & Assembly

read first REVIEW BEFORE ASSEMBLY

• No tools are required for assembly

• For best results, follow the Steps

in the order they are presented

To assemble the BASE,

you will need these pieces:

• When cleaning the cage and

components, use a soft cloth

or Teflon-resistant scrubber,

such as Prevue’s Cage Saver

non-abrasive scrub pad (#109).

• Wash the cage and all compo-

nents with warm water and a

mild, environmentally-friendly,

pet-safe soap. Rinse all parts

thoroughly.

• Hand dry parts completely with

a soft dry cotton cloth before

reassembling the cage. Do not

leave plastic components to dry

in the sun, as they may warp.

CLEANING

INSTRUCTIONS

Start at the bottom. Pull

the bottom wire hook from

the side panel onto the outer

wire of the back panel.

Keep the loop bend to the

inside of the cage.

Continue up the seam and

catch the remaining hooks

onto the back panel.

Front and back:

Position the bottom wire

between the rim and the

raised tabs in the base.

Sides:

Insert the wire loops

(two per side) into the

slots along the base rim.

To assemble the CAGE BODY,

you will need these pieces:

Attach the cage body to

the base:

PAGE 1
read first REVIEW BEFORE ASSEMBLY • No tools are required for assembly • For best results, follow the Steps in the order they are presented CLEANING INSTRUCTIONS • When cleaning the cage and components, use a soft cloth or Teflon-resistant scrubber, such as Prevue’s Cage Saver non-abrasive scrub pad (#109).
PAGE 2
4 To install the COMPONENTS, you will need these pieces: Perches: Insert the longer perch on a vertical wire, resting on a horizontal wire for stability. Install the shorter perch on a horizontal wire, from cage front to back. When installing perches, stagger their placement to allow birds room to sit, walk, and move about. Food/water cups: Assemble the two-piece cup. Hold the snap-hinge door open with one hand and insert the cup with the perch step facing the cage interior.