General Mobile Radio Service (GMRS) 1202 Model : GMRS9010-2 Owner’s Manual HI LO BUSY S/VOX MIC MODE WB Customer Service 1-800-290-6650 128-7032B 1 of 28 Released: 2-10-04 Revision A: 3/3/04 Changes to power on/off, keylock and battery charge functions. Revision B: 5-14-04 Changed battery alert and output power functions.
THIS PAGE LEFT BLANK INTENTIONALLY 2 128-7032B 2 of 28
CAUTION SAFETY INFORMATION Your wireless hand-held portable transceiver contains a low power transmitter. When the PTT button is pushed (or the VOX mode is enabled) it sends out radio frequency (RF) signals. The device is authorized to operate at a duty factor not to exceed 50%. In August 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless devices.
WARNINGS: Battery Care Never attempt to charge alkaline or dry cell batteries, as batteries may burst causing personal injury and damage to the product. If rechargeable batteries are used, such as Nickel Metal Hydride (NiMH), use only Audiovoxapproved rechargeable batteries. Use of the optional Audiovox charger with other brands of batteries is not recommended, as battery charging times will vary with different brands. Refer to the Manufacturer’s instructions for charging other brands of batteries.
Model GMRS1202 (FCC License Required) 6 5 8 4 3 15 16 PTT M 11 14 S/VOX 2 3 (REF) MIC MODE WB 10 9 1 (REF) 13 1 12 7 17 1. 2. 3. 4. 5. 6. Battery Door Monitor/Backlight Button Detachable Carry Clip Push-To-Talk (PTT) Button Antenna External Speaker(SPK)/Microphone (MIC)/Charge (CHG) Jack 7. Built-in Speaker 8. Liquid Crystal Display (LCD) 9. Built-in Microphone 10. Up Channel/Volume Button 11. Down Channel/Volume Button 12. MODE/Weather Button 13. Power On/Off Keylock Button 14.
Model GMRS1202 DISPLAY 1 8 2 9 3 4 5 HI LO BUSY 10 11 12 13 6 14 7 1. Beep Tone Indicator: Icon appears when beep button confirmation tone is selected; icon disappears when tone is off. 2. Key Lock Indicator: Icon appears when the keypad is locked. This function disables keys such as channel up/down, SCAN and MODE. 3. Monitor Indicator: Icon appears when the Monitor (M) button is pressed and the channel monitor function is activated. 4.
12.Small Segment Display: Displays the CTCSS tone option for each main channel from 01-38. 13.Dual Watch Mode Indicator: Indicator appears when dual watch mode is active. 14.Voice Activated Transmission (VOX) Indicator: This function allows hands free conversation. The indicator appears when the VOX mode is activated. Equipment and Accessories Supplied 1. Radio (2) GMRS1202 2. Owner’s Manual 128-7032A 3. Earbud with Remote PTT Button GMRSBHST8 Optional Equipment and Accessories 1. Desktop Charger GMRS9DS 2.
(purchased separately) when charging batteries internal to the unit. NOTE: To extend battery life, avoid overcharging the batteries 3. Various Brands of Rechargeable Batteries - Use of the optional Audiovox charger with other brands of rechargeable batteries is not recommended, as battery charging times will vary with different brands of batteries. Refer to the manufacturer’s instructions for charging other brands of batteries.
The following guidelines will improve performance and provide longer operating times for the GMRS1202: 1. Do not mix old and new batteries. 2. The use of alkaline-type batteries is recommended to provide the longest operating time. 3. Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. 4. If the unit is not to be used for an extended period of time, remove the batteries. Old or leaking batteries can cause damage to the unit and will void the warranty.
Controls: LED Flashlight Button (16) Press this button on the right side of the Transceiver to light the white LED (15) on top of the unit, thereby activating the built-in flashlight function. Power On/Off/Keylock (13) Button ) momentarily (less To turn unit on, press the power on/off button ( than 1 second). A confirming melody will play to indicate the unit has turned on. A momentary pressof the ON/OFF button again will turn the unit off.
Push To Talk (PTT) Button (4) Pressing and holding this button will allow you to speak to any transceiver that is set to the same channel and privacy code setting as yours. Hold the transceiver approximately 1 to 2 inches from your face as you speak into the built in microphone (9). After you have finished speaking, release the PTT Button to allow reception of incoming signals. It is not possible to transmit and receive at the same time.
mode; the VOX icon will appear in the bottom right corner of the display when enabled. Operating Modes and Features GMRS Operation: - From GMRS/FRS standby mode, press and hold the ( ) button for 2 seconds to turn on power. - Press the MODE button so the Channel number flashes. - Select the desired channel with the Up (10) and Down (11) Buttons. When receiving a call, the BUSY icon appears to indicate the incoming signal.
Before transmitting on the selected channel, press the Monitor (M) Button (2) to check the activity on that channel. If there is activity on the selected channel, change to another channel that is clear. To change the channel: - From GMRS/FRS standby mode, press the MODE button (12) once or until the channel number flashes. - Press the Up Button (10) briefly to move to the next higher main channel number. - Press the Down Button (11) briefly to move to the next lower main channel number.
The CTCSS subcodes do not prevent others from hearing your transmission. This will only allow you to ignore all traffic on a given channel not using the same subcode. Transmit Power Selection Mode This feature permits selection of the transmitting power level to high or low. When operating on FRS only channels (8-15), no power selection is possible or is displayed. Using low power, the unit will have a lower transmit range, but battery life will be increased.
dual watch channel. Received signals will be played for 5 seconds, then the unit will resume scanning the two channels. Pressing the PTT button during a received transmission will set the unit to transmit on the same channel. Pressing the PTT button when no signal is received will set the unit to transmit on the primary channel. To set the Dual Watch Mode: - From GMRS/FRS standby mode, press the MODE button 5 times (4 times for FRS); DW appears flashing on the display.
- Press the PTT button momentarily to confirm selection. When the key tone feature is on, the Bell icon appears steady on the display, and the beep tones sound in response to button activation. Roger Beep Tone The Roger Beep is a tone which is automatically transmitted whenever the PTT button is released. This tone alerts the receiving party that the transmission has been terminated intentionally.
NOTE: While the scan function is active, the MODE button will be inoperative. The scan mode will reduce the overall battery life since the battery save function is overridden. To enable the channel scan mode: - From GMRS/FRS standby mode, momentarily press the SCAN But ton; (SCAN) will appear on the LCD display. - The radio will display each channel (1-22) in ascending order as the scan mode operates to find an active main channel.
VOX Enable Operation This option enables you to have hands-free conversation. Your voice or nearby sound is detected and the radio transmits without the need to press the PTT button. To enable VOX operation: - From GMRS/FRS standby mode, press the SCAN button for 3 seconds or until the VOX icon appears steady on the display. - Press the PTT button momentarily to confirm VOX enable mode. - To disable the VOX mode, press the SCAN button for 3 seconds or until the VOX icon disappears from the display.
- Momentarily press the MODE button again to access the weather alert function; the weather icon ( ) and AL on or oF appear flashing on the display. - Use the Up or Down buttons to enable (on)/disable (oF) the alert function. The weather icon will stop blinking on the display in the GMRS mode when the alert is disabled. - Press the PTT Button to confirm your selection. - Press and hold the MODE button for at least 2 seconds to exit the weather function.
Warning • Do not operate the transceiver unless you are licensed to do so. • Remove the batteries from the transceiver if it is not expected to be used for long periods. This will eliminate the possibility of chemicals leaking from the batteries and corroding the transceiver. • Avoid exposing the transceiver to water or extremes of temperature. • Do not use this device in or near a mining facility, which uses remotely triggered explosives or in areas labeled “Blasting Area”.
Troubleshooting Problem Possible cause Correction No transmission while pressing the PTT Button Weak batteries Incorrect battery polarity Charge or replace batteries Install the batteries following the directions in paragraph Installing the Batteries.
Technical Specifications: General Frequency Range: Channels 1-7 (Shared with FRS Radios) Channels 8-14 (FRS only) Channels 15-22 (GMRS only) Channel Spacing Privacy Codes Weather Band (7 Channels) Canadian Maritime (3 Channels) Dimensions (W x H x D) (Without Antenna) Power Supply Power Source Operating Time: (Transmit: Receive: Standby (5:5:90 Ratio) (Based on alkaline batteries) Refer to frequency chart on next page Refer to frequency chart on next page Refer to frequency chart on next page 12.
This transceiver complies with FCC regulations for use in the United States of America. Use in other countries may be prohibited or restricted by local regulation. Please check with the local regulating agency before using this device outside the United States of America. Main Channel Frequencies: CHANNEL /TYPE FREQ (MHz ) CHANNEL /TYPE FREQ (MHz ) 1 GMRS/FRS 462.5625 12 FRS 467.6625 2 GMRS/FRS 462.5875 13 FRS 467.6875 3 GMRS/FRS 462.6125 14 FRS 467.7125 4 GMRS/FRS 462.
CHANNELCROSS REFERENCE FOR 14 AND 15 CHANNEL GMRS/FRS RADIO TO 22 CHANNEL GMRS/FRS RADIO CHANNELCROSS REFERENCE FOR 15 CHANNEL GMRS/FRS RADIO TO 22 CHANNEL GMRS/FRS RADIO 15 C H A N N E L GMRS 22 C H A N N E L FRS/GMRS CHANNEL CROSS REFERENCE FOR 14 CHANNEL FRS RADIO TO 22 CHANNEL GMRS/FRS RADIO 14 C H A N N E L FR S 22 C H A N N E L FRS/GMRS 1 1 1 1 2 2 2 2 3 3 3 3 4 4 4 4 5 5 5 5 6 6 6 6 7 7 7 7 CHANNELS NOT AVAILABLE 8 8 8 9 9 9 10 10 10 11 11 11 12 12 12 1
Continuous Tone Coded Squelch System Tone Frequencies (in Hz) CTCSS Freq. Hz CTCSS 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 67.0 71.9 74.4 77.0 79.7 82.5 85.4 88.5 91.5 94.8 97.4 100.0 103.5 107.2 110.9 114.8 118.8 123.0 127.3 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 Freq. Hz 131.8 136.5 141.3 146.2 151.4 156.7 162.2 167.9 173.8 179.9 186.2 192.8 203.5 210.7 218.1 225.7 233.6 241.8 250.3 * oF = No Tone Weather Channel Frequencies: Channel 1 2 3 4 5 Channel Freq. MHz 162.
90 DAY LIMITED WARRANTY Applies to Audiovox Family Radio and General Mobile Service Products. AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 90 days from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.
THIS PAGE LEFT BLANK INTENTIONALLY 27 128-7032B 27 of 28
© 2004 Audiovox Electronics Corp.
[RF EXPOSURE STATEMENT : PDHGMRS1202 / TTI TECH CO., LTD.] - CAUTION! - IMPORTANT SAFETY INFORMATION Your wireless hand-held portable transceiver contains a radio frequency transmitter. When the PTT button is pushed, the transmitter sends out RF signals. The device is authorized to operate at a transmit duty factor not exceeding 50% using Ni-Mh / alkaline “AAA” size batteries to comply with Federal Communications Commissions (FCC) RF exposure safety level guidelines for hand-held wireless devices.