Instruction Manual Retro AM/ FM Radio with Bluetooth Gaumont/ AM29
Getting to know your Retro FM/AM Radio/B T You’ll be up and running in no time Ready? Let’s begin... Please read these instructions carefully. They contain important information which will help you get the best from your product and ensure safe and correct installation and operation. If you require any further assistance, our technical experts are happy to help. For full details, refer to the product support section at the end of these instructions. Your Retro FM/AM Radio/BT - Outview Fig 1.
Your Retro FM/AM Radio/BT Outview 4 5 6 7 8 9 10 11 1. AC in jack (AC/AC Power adaptor) 2. Earphone jack 3. Battery compartment 4. Telescopic antenna 5. Function select switch 6. FM Function indicator LED 7. AM Function indicator LED 8. BT Function indicator LED 9. Volume control knob 10. Tuning knob 11.
U s ing your Retro FM/AM Radio/B T Connection 1. Connect the AC/AC power adaptor to ‘AC IN’ jack on the back of the Radio and fully extend the radio aerial in a vertical position to obtain the maximum signal strength. 2. Plug the AC/AC power adaptor into the mains power wall socket and switch on. 3. Slide the OFF/FM/AM/BT function switch to select mode (AM/FM/BT). Inserting the batteries (optional) 1.
U s ing your Retro FM/AM Radio/B T Switch off Slide the OFF/FM/AM function switch to ‘OFF’ position. To completely switch off the Radio, switch off the mains power at the wall socket. Adjusting the volume Turn the rotary volume wheel on the top of the radio, anti-clockwise to decrease the volume and clockwise to increase the volume. Telescopic aerial Please make sure that the aerial on the back of the Radio is fully extended before you attempt to tune to an FM station.
AM Radio mode Slide the function switch to the AM position, the FM indicator LED (7) will be on. Tuning to an AM station In AM mode: Use the rotary tuning dial on the front of the radio to tune to your favourite AM station. Please use the frequencies marked on the dial as a guide. The tuning dial will move both clockwise and anti-clockwise but does have a ‘stop’ point. If you turn the tuning dial and reach the ‘stop’ point, please turn the dial in the opposite direction to tune.
GAUMONT Technical data Power source: Power adaptor: Input AC: 120V~/60Hz Input:120V~ 60Hz 5W Output:5.0V~, 400mA Batteries: 4 x 1.5V C size (LR14) (Optional, not supplied) Frequency range: AM: 520 - 1710 KHz FM: 88 - 108 MHz BT: 2402 - 2480 MHz Any support you need, anything you feel like to share, You are more than welcome to contact us. customerservice@ttinno.com FCC ID: 2AVTM-GAUMONT This device complies with Part 15 of the FCC Rules.