User's Manual

ManualsBrandsTsuen Shing Enterprises ManualsBaby MonitorsReceiver Unit of Baby Monitor

CAUTION

This product cannot replace responsible adult supervision.

BM 142 User Manual

Congratulations

You have just purchased a quality baby monitor. Please read the instructions thoroughly before

using the monitor system and keep it for future reference.

Key / Button Index

AC Adaptor:

The AC Adaptors are low voltage power sources that allow you to use your household electricity

to run the Baby Monitor. Connect the AC Adaptors to the AC Adaptor Jack in the Parents and

Baby Units. Both plug into any standard volt electrical outlet in your home. It is recommended

to turn off the units before plug or unplug the adaptors.

CAUTION: These adaptors were made with a specific design for this product. They cannot be

used with any other appliance. Never use a different type of adaptor with this monitor.

Important!

- This Baby Monitor is intended as an aid. Do not use it as a medical monitor or a substitute

for responsible and proper adult supervision.

- Make sure the Baby Unit and adaptor cable are always out of child’s reach. Do not place

the Baby Unit inside the baby’s crib or playpen!

- The antenna on the Parents and Baby Units are fixed, do not try to extend them. Never

attempt to modify the product.

- Avoid using the system near water.

Parents & Baby Units Battery Installation

1. Locate the battery compartment door on the back of the Parents and Baby Units.

2. Open the battery compartment door.

3. Insert 3 pieces of supplied re-chargeable batteries into the Parents Unit and insert 3 AAA

alkaline batteries into the Baby Unit.

4. Replace battery compartment doors.

Battery Tips:

- If the system is not in use for a long time, disconnect both units from the household electrical

outlet. And remove the batteries or the exhausted batteries from the units, otherwise battery

leakage and corrosion can damage them.

- Dispose the batteries safely.

- Non-rechargeable battery is not to be recharged

- Rechargeable batteries are only to be charged under adult supervision.

Summary of content (5 pages)

PAGE 1
BM 142 User Manual Congratulations You have just purchased a quality baby monitor. Please read the instructions thoroughly before using the monitor system and keep it for future reference. Key / Button Index AC Adaptor: The AC Adaptors are low voltage power sources that allow you to use your household electricity to run the Baby Monitor. Connect the AC Adaptors to the AC Adaptor Jack in the Parents and Baby Units. Both plug into any standard volt electrical outlet in your home.
PAGE 2
Only the batteries of the same and equivalent type as recommended in the “Battery Installation” instructions are to be used. Parents & Baby Unit Battery Changing 1. Use only the AC adaptors which are included in the package, Plug into any nearby standard household electrical outlet. 2. And connect them with the units. 3. It takes 8 hours to charge the re-chargeable batteries full at the first time.
PAGE 3
Setup & Use IMPORTANT! Test sound reception before use and whenever location of transmitter is changed. (Refer to Testing Before First Time Usage) - - Baby Unit detects sound levels within a range of 1 to 2 meters (3 to 6.5 feet) for NORM setting. Place Baby Unit in the same room with child. Point microphone directly toward child location, such as crib or playing area. Set both Parents and Baby units to the same channel (1 or 2) Push Baby Unit SESITIVITY switch to NORM or HIGH position.
PAGE 4
- - Sound sensitivity level of Baby Unit is too low, Turn the Sound Sensitivity switch on Baby Unit to High position. Units are out of range. Move Parents Unit closer to Baby Unit Ensure both units are in the same channel. 4. Hearing static or buzzing from Parent Unit - Make sure both units are set to the same channel Move the Parents Unit closer to the Baby Unit Note: Communication range varies depending on surrounding conditions such as physical obstructions, interference. 5.
PAGE 5
FCC Statement Warning: changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.