User Manual

ManualsBrandsTsuen Shing Enterprises ManualsBaby MonitorsBaby Monitor

BM-148 USER MANUAL

Congratulations

You have just purchased a quality baby monitor. Please read the instructions thoroughly

before using the monitor system and keep it for future reference.

Safety Precautions

When using this unit, basic Safety Precautions should always be followed to reduce the

risk of fire, electric shock, or personal injury.

1. Read and understand all instructions.

2. Follow all warnings and instructions marked on this unit or mentioned in this operation

instruction.

3. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.

4. Do not use this unit near water such as bathtub, shower or pool. Immersion of this unit

in water could cause an electrical shock.

5. Place the unit securely on a stable surface. Serious damage and/or injury may result if

the unit falls.

6. Do not cover slots and openings on the unit. They are provided for ventilation and

protection against overheating.

7. Install the unit where no one can step or trip on the cord.

8. Never push any objects through slots in this unit. This may result in the risk of fire or

electric shock. Never spill any liquid on the unit.

9. To reduce the risk of electric shock, do not disassemble this unit. Take the unit to

authorized service center or qualified technician when service or repair work is required.

Opening or removing covers may expose you to dangerous voltages or other risks.

Incorrect reassembly can cause electric shock when the unit is subsequently used.

10. Do not expose the unit to extreme temperatures such as areas near a hot radiator or

stove or in a hot car.

11. Do not place lighted objects such as candles, cigarettes on the unit.

Caution:

This product cannot replace responsible adult supervision.

z This Baby Monitor is intended as an aid. Do not use it as a medical monitor or a

substitute for responsible and proper adult supervision.

z Make sure the Parents unit and adaptor cable are always out of child's reach. Do not

place the Baby Unit inside the baby's crib or playpen!

WARNING:

To prevent the risk of fire or electrical shock, do not expose this unit to rain or any type of

moisture.

Summary of content (14 pages)

PAGE 1
BM-148 USER MANUAL Congratulations You have just purchased a quality baby monitor. Please read the instructions thoroughly before using the monitor system and keep it for future reference. Safety Precautions When using this unit, basic Safety Precautions should always be followed to reduce the risk of fire, electric shock, or personal injury. 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on this unit or mentioned in this operation instruction. 3.
PAGE 2
Content and Features LCD version: Baby unit Parents unit LED Indicator version: AC Adaptor for Parents unit AC Adaptor for Baby unit Parents unit Baby unit Baby unit : LCD version 4 5 1a 2 6 7 9 10 8 3 11 LED Indicator version 4 1b 5 6 2 3 7 9 10 2 8 11
PAGE 3
1a. LCD Display (for LCD version) 1b. Power Indicator : Red, Green and Orange (for LED Indicator version) 2. Microphone 3. Speaker 4. Belt Clip 5. Lock / Unlock key 6. Battery Compartment 7. Power and Volume Control 8. AC / DC Power Supply Sock 9. PAGE key 10. Music Play and Control (optional) 11. LINK key Parents unit : LCD version: 5 6 1a 7 10 3 8 11 4 9 12 13 LED Indicator version: 1b 2 5 6 7 3 8 4 9 10 11 12 13 1a. LCD display (for LCD version) 1b.
PAGE 4
. Speaker 5. Belt Clip 6. Lock / Unlock key 7. Battery Compartment 8. Power and Volume Control 9. AC / DC Power Supply Sock 10.TALK key 11.PAGE key 12.Music Play and Control (optional) 13.LINK Key Indication LCD version : Main LCD Screen Out of range alarm icon Selected Music (for Music function version): 01-06 or AL 01-06 : Music 01- Music 06 . The selected song will be playing repeatedly. AL : Play All music – Music is looped from 01 to 06 repeatedly.
PAGE 5
AC Adaptor: The AC Adaptors are low voltage power source that allow you to use your household electricity to run the Baby Monitor. Connect the AC Adaptors to the AC Adaptor Jack in the Unit. Both plug into any standard volt electrical outlet in your home. It is recommended to turn off the units before plug in or unplug the adaptors. CAUTION: These adaptors were made with a specific design for this product. They cannot be used with any other appliance.
PAGE 6
z Danger of explosion if battery is incorrectly replaced. Replace only with the batteries of the same and equivalent type(TSUEN SHING, BT-101-AC). Battery Charging If the battery level becomes low, the units will display the below : Model Baby Unit Parent Unit Power indicator flashes Red light. LED Indicator version No Alert sound Emits a alert tone (Di Di) in every 3 seconds.
PAGE 7
Fully charged (Unit is turned off.) Red light The battery icon is full and stops flashing. Note: z User can also install 3 alkaline AAA batteries instead of the supplied re-chargeable batteries. z Or directly operated by the supplied adaptors. Help protect the environment Batteries with symbols shown opposite must not be disposed in general domestic waste.
PAGE 8
Constantly changing display-readouts 4. The transmitter is standby status when no signal is transmitted. LCD version LED Indicator version Flashing Green light C. Parents unit reception: 1. Place Parents unit in room where you intend to use it. 2. Slide the VOLUME switch to a desired position and the unit is ready for reception. 3. If the unit receives a signal, LCD version LED Indicator version Green light Green light Constantly changing display-readouts 4.
PAGE 9
B. Volume Adjustment Rotate for adjusting the desired volume level. 1. Turning it upward for increasing volume level; 2. Turning it downward for decreasing volume level. C. Talk to Baby unit (Only for Parents unit) TALK key is located at the left side of the Parents unit. 1. Press and hold TALK key to talk to the Baby unit. 2. Release TALK key and return to the receiving status. Remark : When the Parents unit is talking to the Baby unit, the call ring tone can also be heard if press PAGE key of Baby unit.
PAGE 10
1. Press PAGE key at the left side of the Parents unit or Baby unit one time to call another unit. 2. Three “BiBi” sound will be heard from Baby unit or Parents unit. 3. Each press PAGE key once, you will hear three “Bi Bi” sound. If no press PAGE key again, the call ring tone will end. Remarks: - When Baby unit call Parents unit, only the Parents unit can be heard three “Bi BI” sound ( and power LED of Parents unit flashes RED light for LED indicator version.
PAGE 11
J. Belt Clip The Baby unit and Parents unit can both be carried around using the belt clip provided on the rear of each unit. How to operate 2 way communication between Parents unit and Baby unit The Baby Phone yields high privacy and almost zero-interference to end users. There are more than 65000 ID code for user selection with the LINK key positioned at the bottom of the units. NOTE: Only scan the corresponding code for both units, they are able to connect to one another. Operating and Setup A.
PAGE 12
Scanned the corresponding code successfully Parent unit OR normal status Scanned the corresponding code unsuccessfully Baby unit Both units : constantly changing display-readouts Red/ Green light with a “Di” sound with a “Di” sound Parent unit: Parent unit: still flashing Baby unit: still flashing still Orange light Baby unit: still Orange light Remarks: If operated by the supplied adaptor, please first plug in the adaptor, then power on the unit.
PAGE 13
2. Message not transmitted. - Sound sensitivity level of Baby unit is too low, turn the sound sensitivity switch to “HI” position. - Units are out of range or lost connection. Ensure the distance between the units within communication range. Note: Communication range varies depending on surrounding conditions such as physical obstructions, interference. - Make sure the TALK key of Parents unit is not pressed. - Make sure the unit is unlocked. - Ensure both units have already scanned the corresponding code.
PAGE 14
Operating Range: up to 300m in ideal conditions up to 100m in ideal conditions(for Blue Angel version) Mic Sensitivity : 1 to 2 meter FCC Statement: Caution: The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the user’s authority to operate this equipment. Notes: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.