User's Manual

UserManual

1.LaunchtheACAvalancheRechargeapp,andpress“START.”Youmayneedtoenablelocationand

thengivetheapplocationpermissionstocontinue.ThisisarequirementofAndroidv6.0andyour

personalinformationwillneverbecollectedorshared.

2.Removethebatterypulltab(first

timeonly)andturnonSmart Chip PCBbyslidingthepowerswitch

totheright.AredLEDlocatedonthetopleftoftheNAPAlogowillflashonce,indicatingthedeviceis

poweredon.

3.MakesureyouhaveBluetoothenabledandthatyour

Smart Chip PCBisturnedonandwithinrange

ofyourdevice.

Smart Chip PCBwillautomaticallyconnecttoyourphone.Thisprocessmaytakeupto

15‐20seconds.

4.Hold

Smart Chip PCBatleast5feetawayfromvehicleoutofdirectsunlight.Presstheorangebutton

onyourscreentomeasuretheambienttemperatureandhumidity.Thebuttonwillturngreenwhen

complete.Iftemperaturereadingishigherorlowerthanyouknowittobe,press“Back”toclearit

and

takeanotherreading.

5.Place

Smart Chip PCBinvehicle’scenterairvent.Ifvehicleisindirectsunlight,opendoors

temporarilytoallowhotairtoescape.

6.Starttheengine,thensetvehicle’sA/Ccontrolstomaximumcoldandmaximumairflow.Makesure

allwindowsanddoorsareclosed.

7.The

Smart Chip PCBwillnowreadthetemperaturefromthevehicle’sairvents.Followthe

instructionsonthecanofrefrigeranttoproperlychargeyourA/C.Theorangeindicatoronyourscreen

willturntogreenwhenyouhavereachedtheoptimumfill.Note:Raisingvehicle’sRPMaboveidlemay

givelowertemperature

readings.



PAGE 1
User Manual 1. Launch the AC Avalanche Recharge app, and press “START.” You may need to enable location and then give the app location permissions to continue. This is a requirement of Android v6.0 and your personal information will never be collected or shared. 2. Remove the battery pull tab (first time only) and turn on Smart Chip PCB by sliding the power switch to the right. A red LED located on the top left of the NAPA logo will flash once, indicating the device is powered on. 3.
PAGE 2
FCC statement: § 15.19 Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.