User Manual

BLUETOOTH MODULE INSTALLATION GUIDE

BT-EM01, BT-EM101

Bluetooth wireless technology is a low-power consuming way to communicate between devices. It has a

maximum range of 30 feet (10m). The Bluetooth device connects to your printer’s serial port and confirms to V2.0

+ EDR of the Bluetooth specification.

Installing the Bluetooth Device to the Printer

Please follow the steps below to install the Bluetooth device.

1. Turn off the printer power.

2. Plug in the Bluetooth device into the RS-232 port.

3. Fasten the device by two screws.

Setting the Communication Settings

For industrial printer, the RS-232 communication parameters can be configured from the LCD control panel by

the following procedures.

1. Turn on the printer power.

2. Enter the main menu.

3. Select Serial Comm. Option.

4. Make sure the communication parameters are set to 115200 bps baud rate, None parity, 8 data bits, 1

stop bit.

For desktop printer models, the RS-232 communication parameters can be setup following command

Syntax:

SET COM1 115, N, 8, 1

P/N: 39-0000-00LF

Baud Rate -- Parity -- Data Bite -- Stop Bits -- Exit

Serial Comm.

Bluetooth device

Screw

LED indicator

Note:

This RS-232 interface of Bluetooth device is used with

the printer only.

PAGE 1
BLUETOOTH MODULE INSTALLATION GUIDE BT-EM01, BT-EM101 Bluetooth wireless technology is a low-power consuming way to communicate between devices. It has a maximum range of 30 feet (10m). The Bluetooth device connects to your printer’s serial port and confirms to V2.0 + EDR of the Bluetooth specification. Installing the Bluetooth Device to the Printer Please follow the steps below to install the Bluetooth device. 1. Turn off the printer power. 2. Plug in the Bluetooth device into the RS-232 port. 3.
PAGE 2
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.