Instruction Manual

Wireless Charger 45481
I
NSTRUCTION MANUAL
A).Description
Wireless charger for smartphones under the Qi‐standard. Easy to charger your phone without cables, just put your
phone on the charging plate. Please keep reading the following safety notes before use or examination.
B).Primary technical specification of the marking on the product
Input Voltag: DC 5V/1.5A (Optional:5V 1A) Charging Frequency: 112‐205 kHZ Charging Distance:＜6mm The
interface type: Micro 5 Pin USB interface
C).Operation instruction
1.The peoduct is used only indoor or at the dry location. 2.Don't store or use this product in the erosional
condition. 3.The temperature around the product must be kept as indoor temperature
and should avoide over heat or cold .It would effect the characteristic and working life.
4.According to the technical specification of product, wireless charger should be connected with an AC adaptor
with requested spec and specified smartphones. Please notice if input voltage & current is complied. A qualified
AC adaptor is recommended
5.Way to work 1)When the power is switched on, the red and blue LED blink three times then extinguishing.
2)When putting on the phone to charge, the blue light will go out after the 6S, and continue to
charge until it is full and the light is not on 3)Protection of foreign object detection, over‐heat protection,
overload protection, etc. Until normal. 6.If you have any technical question,please do not hesitate to consult the
supplier directly.
D).Conforming to standard
FCC ID: 2AOOP‐Q05W1
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment
and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help. Note: The Grantee is not responsible for any
changes or modifications not expressly approved by the party responsible for compliance. such modifications could void
the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement.
To maintain compliance with FCC's RF exposure guidelines, the distance must be at least 20 cm between the radiator
and your body, and fully supported by the operating and installation configurations of transmitter and its antenna(s).