User Manual Part 3

5 65
Presenter
AP
l
l
7
8
Screen Black
Power Point Page Up
Return to the last page in the power point.
Power Point Page Down
Go to the next page in the power point.
many
s.
(7) Make sure the software is installed completely. Please check if the Remote Presenter Mouse 
appars in the list of the Mouse Device under Device Manger. If No, Please reinstall again.
charging cardle or the
9.
"Programmable Buttons"
FCC statement
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation if this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example-use only
shielded interface cables when connecting to computer or peripheral devices).
FCC &IC Radiation Exposure Statement
Channel
The Wireless Channel sets the radio frequency used for communication.
● Access Points use a fixed Channel. You can select the Channel used. This allows you to choose a
Channel which provides the least interference and best performance. In the USA and Canada, 11
channel are available. If using multiple Access Points, it is better if adjacent Access Points use different
Channels to reduce interference.
● In "infrastructure" mode, Wireless Stations normally scan all Channels, looking for an Access point. If
more than one Access Point can be used, the one with the strongest signal is used. (This can only
happen within an ESS.)
IF using "Ad-hoc" mode (no Access Point), all Wireless stations should be set to use the same Channel.
However, most Wireless stations will still scan all Channels to see if there is an existing "Ad-hoc" group
they can join.
The device complies with
* USA models: Part 15 of the FCC Rules.
* Canada models: RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference. and
(2) This device must accept any interference received, including interference that may
cause undesired operation.