DH 105 S / DH 115 S / DH 145 SH EN TRT-BA-DH105S-DH115S-DH145SH-TC211118TTRT01-004-EN ORIGINAL INSTRUCTIONS CONDENSER DRYER
You can download the current version of the instructions via the following link: Table of contents Notes regarding the instructions .......................................... 2 Safety ..................................................................................... 2 DH 105 S Information about the device................................................ 4 Transport and storage........................................................... 6 Assembly and start-up.............................................
• • • • • • • • • • • • • • • • • • • EN Only put up the device in an upright, stable position on firm ground. Let the device dry out after a wet clean. Do not operate it when wet. Do not use the device with wet or damp hands. Do not expose the device to directly squirting water. Never insert any objects or limbs into the device. Do not cover the device during operation. Do not sit on the device. This appliance is not a toy. Keep away from children and animals.
Residual risks Information about the device Warning of electrical voltage Work on the electrical components must only be carried out by an authorised specialist company! Warning of electrical voltage Before any work on the device, remove the mains plug from the mains socket! Do not touch the mains plug with wet or damp hands. Hold onto the mains plug while pulling the power cable out of the mains socket.
Device depiction DH 115 S DH 105 S 8 8 7 1 1 7 2 2 3 3 4 4 5 5 6 6 9 9 EN condenser dryer DH 105 S / DH 115 S / DH 145 SH 5
DH 145 SH Transport and storage 8 1 7 2 3 4 6 5 9 Note If you store or transport the device improperly, the device may be damaged. Note the information regarding transport and storage of the device. Transport Always utilize the help of another person to transport the device. Do not try to transport the device without the help of another person. To lift the device, use a forklift or an elevating truck as appropriate.
Assembly and start-up • Scope of delivery • • • • 1 x device 1 x Condensation drain hose 1 x Manual Make sure that no curtains or other objects interfere with the air flow. When positioning the device, particularly in wet areas, secure it locally with an RCD (residual current device) which complies with the respective regulations. Inserting the air filter Unpacking the device 1. Open the cardboard box and take the device out. 2. Completely remove the packaging. 3. Fully unwind the power cable.
Positioning the condensation drain hose For continuous operation or unattended dehumidification, please connect the supplied condensation drain hose to the device. ü A suitable hose (diameter: 15 mm) is ready for use. ü The device is switched off. 1. Connect the condensation drain hose to the condensation hose connection (6) at the device. ð Position the end of the condensation drain hose above a water drain. For larger distances, a longer hose of the same type can also be used.
Mains connection A 3/N/PE three-phase socket with clockwise rotating field is required to connect the device. The device is delivered with a CEE phase inverter, 32 A, 6 h. • Insert the plug into the respective CEE socket. If the device does not start up automatically and the error message E5 appears in the segment display, the rotating field in the phase inverter must be corrected. Correct the rotating field in the phase inverter as follows: 1. Pull the plug from the mains socket. 2.
Operating elements DH 145 SH 19 No. Designation 19 Humidity control dial 20 OPERATION indicator light 21 ALARM indicator light 20 21 Meaning Switching the device on and off Setting the desired relative room humidity For activating continuous operation Illuminated during ongoing operation. Illuminated when the wrong rotating field is set in the mains plug. Operating elements condensate pump 3 4 No.
DH 145 SH: You can set the desired humidity level by use of the humidity control dial (19). 1. Turn the humidity control dial (19) clockwise to set a smaller value for the desired humidity level. 2. Turn the humidity control dial (19) counter-clockwise to set a higher value for the desired humidity level. The device keeps running until reaching the desired relative room humidity. Once the desired relative room humidity is exceeded, the compressor and fan switch back on.
Errors and faults The device has been checked for proper functioning several times during production. If malfunctions occur nonetheless, check the device according to the following list. Note The device is equipped with a safety timer. Switch-ons and switch-offs can be delayed by up to 3 minutes. The device does not start: • Check the power connection. • Check the power cable for damages. • Check the on-site fusing. • Check the filling level of the condensation tray and empty it, if necessary.
Maintenance intervals Maintenance Maintenance and care interval before every start-up as needed Empty the condensate pump, condensation tray and/or condenser dryer at least every at least every at least every at least 2 weeks 4 weeks 6 months annually X Check air inlets and outlets for dirt and foreign objects and clean if necessary X X Clean the exterior X Visually check the inside of the device for dirt X Check air inlet grid(s) and air filter(s) for dirt and foreign objects and clean or rep
Activities required before starting maintenance • • Warning of electrical voltage Do not touch the mains plug with wet or damp hands. Switch the device off. Hold onto the mains plug while pulling the power cable out of the mains socket. Warning of electrical voltage Tasks which require the device to be opened must only be carried out by authorised specialist companies or by Trotec. Cleaning the air filter Warning Ensure that the air filter is not worn or damaged.
3. Allow the filter to dry completely. Do not insert a wet filter into the device! 4. Reinsert the air filter into the device. Condensate discharge Drain remaining condensate from the device as follows: 1. Press the button for draining residual water (3). ð The condensate pump transports the remaining condensate out of the condensation tray. ð The condensation tray has been drained completely when the condensate pump does not deliver any more condensate. 2.
Technical data Technical annex Parameter Value Model DH 105 S DH 115 S DH 145 SH Dehumidification performance @ 30 °C and 80 % RH 175 l / 24 h 245 l / 24 h 485 l / 24 h Air flow rate 1700 m3/h 2150 m3/h 4300 m3/h Operating range (temperature) 5 °C to 32 °C 5 °C to 32 °C 5 °C to 32 °C Operating range (relative humidity) 30 % to 90 % RH 30 % to 90 % RH 30 % to 90 % RH Pressure suction side 1.65 MPa 1.65 MPa 1 MPa Pressure outlet side 3.1 MPa 3.1 MPa 2.
Wiring diagram DH 105 S / DH 115 S EN condenser dryer DH 105 S / DH 115 S / DH 145 SH 17
Wiring diagram DH 145 SH 18 condenser dryer DH 105 S / DH 115 S / DH 145 SH EN
Overview of spare parts DH 105 S / DH 115 S Note: The position numbers of the spare parts differ from those describing the positions of the components mentioned in these instructions. No. Spare part No. Spare part No.
Overview of spare parts DH 145 SH Note: The position numbers of the spare parts differ from those describing the positions of the components mentioned in these instructions. No. Spare part No. Spare part No.
Disposal The icon with the crossed-out waste bin on waste electrical or electronic equipment stipulates that this equipment must not be disposed of with the household waste at the end of its life. You will find collection points for free return of waste electrical and electronic equipment in your vicinity. The addresses can be obtained from your municipality or local administration. You can also find out about other return options that apply for many EU countries on the website https://hub.trotec.
Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.