Think Roux fy Think row sre & SAFETY PRECAUTIONS Read the installation and operation instructions carefully before Installing ane operating this device. Proper adherence to these instructions is essential to ensure the cables are sized and instated properly.
Think Roux fr Think row fa] & PACKAGE CONTENTS ® Lx Smart Junction Box (OPS-1} + Exterminate Waterproof Cable Gland Seal (for 12/3 and 14/3 cable) © INSTALLATION STEP 1 The Sr mart Junction Sox is installed between the power source and aur rst LED inline using push-lock connections or the Daisy Chain Power Cord. The main cower supp'y must be hard-wired into the Assert junction doe, STEP 2 To wire the Smart Junction Bax to your facility's primary power source, remove the wo screws and open the chassis.
Think Roux fr Think row fa] STEPS Cora the chassis, then tighten the cable grand rut and re-insert the wo screws to seal the chassis. STEPS Separate the back mount by releasing the 2 screws on both sides of the chassis, Mount the back-rout on the wall, then re-insert the 2 screws on both sides to tighten the chassis. Back-mount © SMART JUNCTION BOX OPERATION INSTRUCTIONS 1. Main Menu Zoned 5 wireless Status. Current Voltage witting Power Garrick Medan Current 2.
Think row A 4. if power exceeds current shut-off point: # The OPA: Willie shut off power If the current raises 2006 above the shut-off point within 0.55. + To resume the OPS-1, press and hold the button for 5 seconds, Think row FE © WIRELESS PAIRING INSTRUCTIONS How fo add the OPS-1 to the Hydro-X Pro. » Before you start, please make sure your main controller (SCH-2) has the Masterstroke Wireless Station (IS-1} connected and addressed. = Go to “Setting”, and move to the next page.
Think Roux fr + Press the Add” button in the top right corer to add a new device. ® Press the button on the OPS-1 three times consecutively to activate the wireless pairing function. The OPS-L will show the pairing iD on the screen, # The OPS-1 will show up on the “Scanning New Device” window with the pairing iD provided, Select it and press "Confirm? Think row sre « Once the OPS-1 is paired, twill show up nth "Wireless Station” ren.
Think row fr Think row fa] © OPERATION INSTRUCTIONS « Users can identify the zone number by looking in the top-left corner of a paired OPS-1 screen. Monitoring with the Energy Meter menu. + Press the “Zone” button on the ‘Energy Meter” Home screen, to enter Zod the “Energy Meter” menu, How fo reset the Energy Consumption Meter « Users can reset the energy consumption meter F necessary. Press the “Reset” button to reset the energy consumption meter.
Think Roux fr Think row fa] How to regent the Energy Consumption Mater = Users can set their own dally operating schedules of the OPS-Lon the Hydro-X Pro controller {SCH-2) ¥ necessary. + Goth "Setting and move to the nex page. Then select the "Wireless Station” menu. # Press "Enter® to select the OPS-1 schedule setting menu corresponding to its' zone. = Add a schedule by pressing the button at the top-right corner of the Bess.
Think Roux fy Think row fa] FCC Statement This device complies with Part 15 of the FCC Rules, Operations subject to the following two conditions: {41} This device may rok cause harmonium interference, and (2) this device must accept any interference received, including interference 4 cause undesired operation. Mote: This equipment has been tested and found to comply with the liniments for a Class B digital device, pursuant to Part 15 of the FCC Rules.