User's Manual

In-Home Cellular Signal Enhancer

Model # BDA1900-2

FCC ID # OEUBDA1900-2

You will find two housings and an AC power transformer in your In-Hone Cellular Signal

Enhancer package. To achieve the best possible performance within your home, follow the

instructions outlined below:

• The In-Home Cellular Signal Enhancer will work best within a room that has the best signal

strength coming from a cell tower. Have your cell phone on and with you as you test the different

areas of the house where you would like to use the enhancer. If your cell phone is not receiving

any signal within a room, the In-Home Cellular Signal Enhancer will not be able to create a signal.

The In-Home Cellular Signal Enhancer is only able to improve a signal that is already present.

• Position the window unit (housing with suction cups and coaxial cable) toward the top of the

glass on a window in a room where you would like to improve an existing signal. The unit should

be a minimum of 2 inches below the window frame to simplify removal of the unit from the

suction cups. The window unit should be positioned so that the coaxial cable is coming out the

bottom of the unit.

•

Connect the window unit to the room unit (larger housing with LED indicator) using the coaxial

cable. Position the room unit on the floor, desk, or shelf (see picture below). Positioning of the

two antennas is very important. The system works best with at least six feet vertical separation

between the housings. If that is not possible, try to have at least 3 feet of vertical separation and

maximize horizontal separation, pointing the room unit away from the window unit. Connect the

room unit to the power supply, and plug the supply into your standard home outlet. The LED

should be green indicating the system is installed correctly. If the LED is either yellow or red, first

confirm that the distance between the two units is correct. If the distances are correct, make sure

there are no physical obstructions, namely metal objects, that could cause interference near the

Two units. To achieve optimum performance, the LED must be green. However, the system will

operate at a reduced performance level if the LED is yellow. If the LED is yellow or red, try

repositioning the units.

IMPORTANT

All antennas need to be installed at least 20 cm (or approximately 8 inches) away

from all persons during normal operation to comply with the FCC’s radiofrequency

radiation exposure requirement.

•

If during the optimization of the unit locations, the LED appears to be reacting slowly, reset the

unit by unplugging the power supply from the outlet and plugging it back in.

PAGE 1
In-Home Cellular Signal Enhancer Model # BDA1900-2 FCC ID # OEUBDA1900-2 You will find two housings and an AC power transformer in your In-Hone Cellular Signal Enhancer package. To achieve the best possible performance within your home, follow the instructions outlined below: • The In-Home Cellular Signal Enhancer will work best within a room that has the best signal strength coming from a cell tower.
PAGE 2
Checklist: □ In-Home Cellular Signal Enhancer must be in a room where you are already receiving a signal from a cellular base station. □ Room unit LED must be either green (best) or yellow (operable). Congratulations! Your In-Home Cellular Signal Enhancer is ready for use. If you have followed the above instructions and would still like installation support, please call 800-471-2012.