Installation Guide

Tritan BP

866-771-2345

www.tritanbp.com

Installation Instructions:

Storage Panels:

 Tritan BP Siding should be climatized for 24 hours prior to installation. If the siding panels have been

stored in a cool climate or at room temperature, they can be installed immediately.

 Siding panels should be stored flat to prevent bowing. If in the unlikely event bowing occurs, place the

panels flat and they will self-correct.

Installing Panels:

 The top of the panel has a protruding lip that will fit behind the panel that is being stacked on top of it.

 Due to the panels being highly textured, it is recommended that all measurements be marked and cut on

the flat backside of the panel.

 Tritan BP siding panels interlock at each end and along the top / bottom. This helps to provide a seamless

look. In many cases, the first panel must have one side of the “fingers” trimmed off to create a straight

edge.

 Panels should be installed onto a clean flat dry surface.

 The panels should be installed from the bottom corner in a straight line. Each panel should be pressed

firmly and tightly against one another for best results. It is very important that the first role of panels is

level and straight for best outcomes. Always install the panels in full rows working your way up. The

horizontal row must be installed before going vertically up. If the floor is not perfectly straight, the

bottom of the panel may need to be slightly trimmed to ensure a straight and level installation.

o When installing the siding, we recommend staggering the first panel. Please see the following.

PAGE 1
Installation Instructions: Storage Panels:  Tritan BP Siding should be climatized for 24 hours prior to installation. If the siding panels have been stored in a cool climate or at room temperature, they can be installed immediately.  Siding panels should be stored flat to prevent bowing. If in the unlikely event bowing occurs, place the panels flat and they will self-correct. Installing Panels:  The top of the panel has a protruding lip that will fit behind the panel that is being stacked on top of it.
PAGE 2
Tritan BP 866-771-2345 www.tritanbp.
PAGE 3
 Apply a generous amount of construction adhesive to each panel. We recommend PL Premium or Enerfoam as the adhesive of choice. Press the panel firmly onto the mounting service and screw or nail the panel into place. o We recommend using TapCon screws if install into concrete block.  Screws / nails should be installed along the tongue among other unnoticeable places. If you need to further conceal a whole, simply apply a little woof filler to the screw whole and once dry apply a little touch up.