Quick Start Guide

SHUTOFF VALVE
Quick Start Guide
FCC and Industry Canada Compliance Statement
This device complies with FCC Rules Part 15 and with Industry Canada license-exempt RSS standard(s). Operation is subject to
two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may be
received or that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada.
Changes or modifications to this equipment not expressly approved by the party responsible for compliance (Triple+ Ltd.) could
void the user’s authority to operate the equipment.
To comply with FCC and IC RF exposure compliance requirements, the device should be located at a distance of at least 20 cm
from all persons during normal operation. The antennas used for this product must not be co-located or operated in conjunction
with any other antenna or transmitter.
Le dispositif doit être placé à une distance d’au moins 20 cm à partir de toutes les personnes au cours de son fonctionnement
normal. Les antennes utilisées pour ce produit ne doivent pas être situés ou exploités conjointement avec une autre antenne ou
transmetteur.
WALLY LIMITED WARRANTY
FOR ONE YEAR from the date of sale this Product has a warranty against defects in materials or workmanship when it is correctly
connected, operated and maintained according to all supplied instructions. If a defect arises and a valid claim is received WITH
PROOF OF SALE within the Warranty Period, then as your sole remedy (and Wally Labs’ sole liability), Wally Labs will at its option
either 1) replace the Product with a new product that is functionally equivalent to the original, or 2) repair the defect at no charge,
using new or refurbished replacement parts, in each case within 30 days following receipt of the returned Product. A replacement
product or part assumes the remaining warranty of the original Product. When a Product or part is exchanged, any replacement
product or part becomes your property and the replaced Product or part becomes Wally Labs’ property. This warranty does not
cover the batteries, which are expendable parts that can wear out from normal use within the warranty period.
This warranty covers ONLY defects in materials and workmanship of the Wally Valve, and will NOT cover:
1. Damage to or failure of the Wally Valve if it is not correctly connected, operated or maintained according to all
supplied instructions.
2. Damage to or failure of the Wally Valve resulting from accident, immersion, alteration, exposure to extreme conditions,
abuse, misuse, or use for other than its intended purpose.
3. Damage to or failure of parts or systems resulting from modifications made to the Wally Valve.
(Note: I removed “unauthorized”.)
4. Damage to or failure of the required ISO5211 ball valve, necessary to the function of the Wally Valve, yet sold separately.
Any issue with the ISO5211 ball valve should be directed to the manufacturer.
WARRANTY SERVICE
To obtain the warranty coverage stated above, return the Product with proof of sale to the retailer from which it was purchased.
Please be prepared to describe the nature of the problem you are experiencing with the product. Any claim under this Limited
Warranty must be submitted to the retailer from which it was purchased before the end of the Warranty Period.
Disclaimer of implied warranties; limitation of remedies
Customer’s sole and exclusive remedy under this limited warranty is Product repair or replacement as provided herein. Implied
warranties, including warranties of merchantability or fitness for a particular purpose, are limited to one year or the shortest
period allowed by law. EXCEPT FOR BODILY INJURY, WALLY LABS SHALL NOT BE LIABLE FOR (I) ANY LOST PROFITS, COST OF
PROCUREMENT OF SUBSTITUE PRODUCTS, OR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, OR (II) ANY AMOUNTS IN
EXCESS OF THE PURCHASE PRICE FOR THE PRODUCT, IN EACH CASE WHETHER RESULTING FROM THE USE OF OR INABILITY
TO USE THIS PRODUCT, EVEN IF COMPANY HAS BEEN ADVISED OF THE POSSIBLITY OF SUCH DAMAGES. Some states and
provinces do not allow the exclusion or limitation of incidental or consequential damages, or limitation on the duration of implied
warranties of merchantability or fitness, so these exclusions or limitations may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Wally Labs LLC, Seattle, WA 98105.
Shutoff Valve Button and LED Behavior
Button Behavior Action LED Behavior
Press and Hold Pair or Un-pair the
Shutoff Valve
Flashes green to indicate it is in pairing
mode
Single Press Manually Open or
Close your Shutoff
Valve
Flashes Orange (good) or Red (bad) to
indicate network status and completion
of the open or close
Double Press Check Network Status Flashes Orange for good network
connectivity or Red if the network
connectivity is bad or unavailable
5 Presses Set Closed Alignment Flashes Blue
Parallel Alignment
Perpendicular Alignment
Note: The stem position line, located
in the center of the Shutoff Valve, in
the perpendicular alignment will be
in-line with the pipe, while in the
parallel alignment the stem will show
in the opposite direction of the pipe.
Download the Wally
®
app or go to my.WallyHome.com and follow the instructions to
connect your Shutoff Valve!
The App Store is a registered trademark of Apple Inc.
Android, Google Play, and the Google Play logo are trademarks of Google Inc.
Quick Start Guide-WSV.indd 1 5/8/17 12:47 PM