User's Manual

ManualsBrandsTrinus Systems ManualsElectronicsWireless Transceiver System, Base Station

Wireless Transceiver System (TPRF-900) Manual

1. Getting Started

. Introduction:

This equipment has been manufactured and tested under strict quality control conditions. This

Wireless Transceiver System has been tested within a 1000 feet radius. The receiving chips use a

Super Heterodyne method, while the Base and Hand sets use and coincides with a Digital Coded method.

In case of frequencies overlapping with other waves, up to 40 different channels can be selected for

clearer reception by manually using the Channel Switch button

. Equipments:

a. Base Set – 1 unit

b. Hand Set – 1 unit

c. Headset (optional) – 2 units

d. Microphone – 1 unit

e. Rechargeable Battery – 1 pack

f. User’s Manual - 1 book

* Accessories parts are subject to change without any notice for functional improvements.

. Cautions:

a. Use only the given antenna with the Base Set

b. Do not immerse in water or keep in humid areas

c. Do not place near TV, speakers, or other electronic devices

d. Before installation, check power supply and voltage to avoid hazards

e. Do not apply force or shock to the unit

f. Do not disassemble the unit

Summary of content (6 pages)

PAGE 1
Wireless Transceiver System (TPRF-900) Manual 1. Getting Started . Introduction: This equipment has been manufactured and tested under strict quality control conditions. Wireless Transceiver System has been tested within a 1000 feet radius. This The receiving chips use a Super Heterodyne method, while the Base and Hand sets use and coincides with a Digital Coded method.
PAGE 2
Parts Description: Base Set: Hand Set:
PAGE 3
2. Functions: This Wireless Transceiver System can automatically search, find, and memorize the best reception within 40 channels. Therefore, top of the line clarity and communication is guaranteed. a. Hand Set: The Talk ON/OFF switch, can activate the Base unit. b. Base Set: The RJ-45 #6 pin is used for controlling the communication. If a LOW (TTL:”L”) signal is received, the communication is enabled regardless the Hand Set is ON or OFF.
PAGE 4
3. Base and Hand Set Installation Base Set a. Connect the RJ-45 connector to the Base Set b. Connect the Microphone (optional Headset) to the Base Set Hand Set a. The battery pack is not built-in the Hand Set for safety reasons. Connect the battery pack to the Hand Set and then turn the power switch ON (located in the battery storage area) b. Prior to use, charge the unit by placing the Hand Set in the Base Set for at least 3~5 hours c.
PAGE 5
4. Rechargeable Battery Pack It is recommended that before using, charge the unit by placing the Hand Set in the Base Set for at least 3~5 hours. Replacing the Battery Pack a. Remove the battery cover on the Hand Set b. Turn the power switch OFF (located in the battery storage area) c. Detach the battery pack cable from Hand Set d. Connect the new battery pack to the Hand Set and then turn the power switch ON (located in the battery storage area) e. Close the battery cover 5. Recommendations a.
PAGE 6
FCC COMPLIANCE STATEMENT THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. Operation is subject to the following two conditions; (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: 1) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.