900MHz DSSS DIGITAL Transmitter/Docking MODEL : TDSS900 USA VERSION User’s Manual TRINUS CO.
900MHz DSSS DIGITAL Transmitter/Docking MODEL : TDSS900 USA VERSION FCC NOTICE This DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED PERATION. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
900MHz DSSS DIGITAL Transmitter/Docking MODEL : TDSS900 USA VERSION √ IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basis safety precautions should always be followed to reduce the risk of life electric shock, and injury to persons, including the following. 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the outlet before cleaning. Do not use liquid cleaners or aerosol cleaners.
900MHz DSSS DIGITAL Transmitter/Docking MODEL : TDSS900 USA VERSION √ SAFETY INFORMATIONS FOR TDSS-900H & TDSS-900B Your TRANSMITTER contains a low power transmitter. When the Push-to Talk button is pushed it sends out radio frequency (RF) signals. This device is authorized to operate at a duty factor not to exceed 50% in DECEMBER 2004 the Federal Communications Commission (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless devices.
900MHz DSSS DIGITAL Transmitter/Docking MODEL : TDSS900 USA VERSION INSTALLATION PRECAUTION 1. Never install docking station wiring during a lighting storm. 2. Never install power jacks in wet locations unless the jack is specially designed for wet locations. 3. Never touch insulated power terminals unless the telephone line has been disconnected at the network interface. 4. Use caution when installing or modifying telephone lines. MAINTENANCE 1. Use a damp cloth to the plastic cabinet.
900MHz DSSS DIGITAL Transmitter/Docking MODEL : TDSS900 USA VERSION CARTON CONTENTS TDSS-900H and TDSS-900B User’s Manual, Warranty and Safety Information Li-Ion 2000mAh 3.7V battery Warranty card TRINUS CO.
WIRELESS TRANSCEIVER SYSTEM TDSS-900 User’s Guide 900MHz Series ● Read this user’s guide carefully for safe operation and proper use of the product . ● Features and specifications are subject to change without notification.
OPERATION (TX) OPERATION (Cradle) 3 1 2 1 4 5 5 1 2 Rec ON/OFF * 2 BEEP * 3 MODE 4 MUTE ON/FF 5 Internal MIC 1 3 Internal MIC 4 Microphone Jack 1. Rec On/OFF: Talk ON – BLUE LED Rec on Blinking Out Of Range – RED LED Fast Flickering Low Battery – RED LED Slow Flickering 2. Beep: Beep Tone 3. Mode: Beep > Vibration > Beep + Vibration > NO action Every time you push the button, mode will be automatically changed in order.
PIN DESCRIPTION RJ-45 Connector Pin Description 8 1 8 1 Pin# 1: VCC, DC power (10V ~ 16VDC) Pin# 2: GND Pin# 3: Audio Signal Pin# 4: Audio Signal GND Pin# 5: GND Pin# 6: None Pin# 7 : 0V when TX is off, 5V when TX is On. Use this pin for recording trigger (Recording Trigger) Normal “H” 5.