2400MHz DSSS DIGITAL Transmitter/Docking MODEL : TDSS2400 USA VERSION User’s Manual TRINUS CO.
.4GHz DSSS DIGITAL Transmitter/Docking MODEL : TDSS2400 USA VERSION FCC NOTICE This DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED PERATION. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
WIRELESS TRANSCEIVER SYSTEM TDSS-2400 User’s Guide INSTALLATION - Connect the battery pack to TX Set and switch the power ON (located on the bottom of TX unit) - Install the bracket by using the screws - Connect the antenna to the RX Set - Slide RX Set onto the Bracket - Connect the RJ-45 cable to RX Set - Prior to use, charge the unit by placing TX set in the RX set for at least for 8 hours - Place TX in RX to match ID - Connect the microphone to TX set THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES
OPERATION (TX) OPERATION (Cradle) 1 1 5 4 2 1 3 2 4 1 Rec ON/OFF * Internal MIC 2 BEEP * Microphone Jack 3 MODE 4 MUTE ON/FF 5 Internal MIC 1. Rec On/OFF: Talk ON – BLUE LED Rec on Blinking Out Of Range – RED LED Fast Flickering Low Battery – RED LED Slow Flickering 2. Beep: Beep Tone 3. Mode: Beep > Vibration > Beep + Vibration > NO action Every time you push the button, mode will be automatically changed in order.
PIN DESCRIPTION RJ-45 Connector Pin Description 8 1 8 1 Pin# 1: VCC, DC power (10V ~ 16VDC) Pin# 2: GND Pin# 3: Audio Signal Pin# 4: Audio Signal GND Pin# 5: GND Pin# 6: VCR ON Pin# 7 : 0V when TX is ON, 5V when TX is OFF. Use this pin for recording trigger (Recording Trigger) Normal “H” 5.